NAVY MIL-T-82535 (1)-1969 TIMER INTERVAL MARK 11 MOD 2 (ASSEMBLY)《集合11号2模时间间隔定时器》.pdf

上传人:proposalcash356 文档编号:982907 上传时间:2019-03-12 格式:PDF 页数:2 大小:73.74KB
下载 相关 举报
NAVY MIL-T-82535 (1)-1969 TIMER INTERVAL MARK 11 MOD 2 (ASSEMBLY)《集合11号2模时间间隔定时器》.pdf_第1页
第1页 / 共2页
NAVY MIL-T-82535 (1)-1969 TIMER INTERVAL MARK 11 MOD 2 (ASSEMBLY)《集合11号2模时间间隔定时器》.pdf_第2页
第2页 / 共2页
亲,该文档总共2页,全部预览完了,如果喜欢就下载吧!
资源描述

1、I MIL-T-82535( OS) Amenaxent 1 28 Jamary i969 ;) . w , . . -. “ . . . . . . , ,. . . . . , ,. . , , . . . . . . 1 a, _. . . . ,I,. . 5 .- MILITARY SPECIFICATION TIMER, INTERVAL, ARK i1 MOD 2 (ASSEMBLY) This amendment forms a part of Miitary Specification MIL-T-82535(0S) of 18 April i968 and has been

2、 approved by the Naval Ordnance Systems Command, Department of the Navy Wherever it appears in specification delete “Bureau of Naval Weapons“ and substitute “Naval Ordnance Systems Command“; also, delete “BuWeps“ and substitute ilvomll. Fage 3. “3.3.5 Resistances and continuity 3.3.5.1 3.3.5.2 Page

3、10, paragraph 4.4.1. Add the following paragraphs: The resistance of circuit E3 to E6 shall be 0.10 ohm maximum. The resistance of circuits E4(+) to El(-) and E(+) to E5(-) shall be 10,000 ohms minimum.“ Add the followAng new item: C. Resistance measuring device Measure resistance from 11 0.10 to 10

4、000 ohms with an error of not more than 5 percent“ - Page 15, Table II: Delete : “Visual examination * 4.6.1.5 . *f Substitute: “Resistance and continiuty * 4.6.1.5 * Visual examination * 4,6.i.6 *tt Page 17, magraph 4.6.1.5. Delete and substitute: 4.6.1.5 Resistance and continuity. Using the devic

5、e specified in 4.4.c., measure the resistance and continuity of the timer cirucits. The circuits and resistance shall be as specified below: 11 Circuit Resistance E3 to E6 0.10 ohmmax. E4(+) to El (-) - 10,000 ohms min. - a+) to E5 (-1 ,O ohms min.“ -9-c- THIS DOCUMENT CONTAINS 2 PAGES. _cc_. - - -

6、/L . - E Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-& MIL-T-82535 (1) 13 7777706 0361825 5 m m-T-82535( OS) k:, 4.6.1.6 Visual examination. Visual examination shall be made on each The tiiner shall be Nonconformance is cause far rejection of individual unit.“ Il tinier submitted for delivery to the procuring agency. examined for conformance to the requirements of god workmanship specified in 3.6. 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

展开阅读全文
相关资源
猜你喜欢
  • ITU-T H 248 84-2012 Gateway control protocol NAT traversal for peer-to-peer services (Study Group 16)《网关控制协议 对等网络的网络地址转换(NAT)追踪 16号研究组》.pdf ITU-T H 248 84-2012 Gateway control protocol NAT traversal for peer-to-peer services (Study Group 16)《网关控制协议 对等网络的网络地址转换(NAT)追踪 16号研究组》.pdf
  • ITU-T H 248 85-2013 Gateway control protocol Usage of loopback in ITU-T H 248 (Study Group 16)《网关控制协议 在型号国际电信联盟-电信标准局 H 248回环使用(研究组16)》.pdf ITU-T H 248 85-2013 Gateway control protocol Usage of loopback in ITU-T H 248 (Study Group 16)《网关控制协议 在型号国际电信联盟-电信标准局 H 248回环使用(研究组16)》.pdf
  • ITU-T H 248 86-2014 Gateway Control Protocol ITU-T H 248 support for deep packet inspection (Study Group 16)《网关控制协议 国际电信联盟-电信标准局 H 248支持深度包检测(研究组16)》.pdf ITU-T H 248 86-2014 Gateway Control Protocol ITU-T H 248 support for deep packet inspection (Study Group 16)《网关控制协议 国际电信联盟-电信标准局 H 248支持深度包检测(研究组16)》.pdf
  • ITU-T H 248 87-2014 Gateway control protocol Guidelines on the use of ITU-T H 248 capabilities for performance monitoring in RTP networks in ITU-T H 248 profiles (Study Group 16)《为.pdf ITU-T H 248 87-2014 Gateway control protocol Guidelines on the use of ITU-T H 248 capabilities for performance monitoring in RTP networks in ITU-T H 248 profiles (Study Group 16)《为.pdf
  • ITU-T H 248 88-2014 Gateway control protocol RTP topology dependent RTCP handling by ITU-T H 248 media gateways with IP terminations (Study Group 16)《通过IP终端的ITU-T H 248媒体网关来处理实时传输协.pdf ITU-T H 248 88-2014 Gateway control protocol RTP topology dependent RTCP handling by ITU-T H 248 media gateways with IP terminations (Study Group 16)《通过IP终端的ITU-T H 248媒体网关来处理实时传输协.pdf
  • ITU-T H 248 89-2014 Gateway Control Protocol TCP support packages (Study Group 16)《网关控制协议 传输控制协议支持包(研究组16)》.pdf ITU-T H 248 89-2014 Gateway Control Protocol TCP support packages (Study Group 16)《网关控制协议 传输控制协议支持包(研究组16)》.pdf
  • ITU-T H 248 9-2009 Gateway control protocol Advanced media server packages (Study Group 16)《网关控制协议 高级媒体服务器包 16号研究组》.pdf ITU-T H 248 9-2009 Gateway control protocol Advanced media server packages (Study Group 16)《网关控制协议 高级媒体服务器包 16号研究组》.pdf
  • ITU-T H 248 90-2014 Gateway control protocol ITU-T H 248 packages for control of transport security using transport layer security (TLS) (Study Group 16)《网关控制协议 为利用传输层安全(TLS)的传输安全控.pdf ITU-T H 248 90-2014 Gateway control protocol ITU-T H 248 packages for control of transport security using transport layer security (TLS) (Study Group 16)《网关控制协议 为利用传输层安全(TLS)的传输安全控.pdf
  • ITU-T H 248 91-2014 Gateway control protocol Guidelines on the use of ITU-T H 248 capabilities for transport security in TLS networks in ITU-T H 248 profiles (Study Group 16)《为ITU-.pdf ITU-T H 248 91-2014 Gateway control protocol Guidelines on the use of ITU-T H 248 capabilities for transport security in TLS networks in ITU-T H 248 profiles (Study Group 16)《为ITU-.pdf
  • 相关搜索

    当前位置:首页 > 标准规范 > 国际标准 > 其他

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1