1、FED. SUP CL4SS 6250 A A&PHQLDER, MINIATURE BI-PIN, 8-WA?T cms .A. iher Cutr FLUORESCENT LIGHTING FIXTUXES WIIE-BS cm. LEAD WIRE L5 APP307ED. 10“ UINC. 2 PIECS. M i l IT A RY ST AH DA - 4 D M s 1 6 5 67 (SHIPS) DIA.- 2 HOLES- XOLDZLI PHE.POLIC BODY.+ X ADH2SfVE -1-7798 REQUIREhTZNTS “ 1. The lamp hol
2、der shall consist of a molded phenolic body, housing two contacts to which lead wires are . securely attached and covered by an insulating backing plate or plates. 2. The molded phenolic body shall be formed with a keyhole slot to allow lamp pins to enter and turn aqd shall have two electrical con6u
3、cting contacts so formed that good electrical contact is ma& and maintainad when the Lamp is rotated 90 from the entering position. The con:acts shall locate and bold lamps In the 90“ posltion. current carrying parts and ground. The source of the test potential shall have a rating of at least 1 kw.
4、9. Lmpholder shall withstand for one minute a dlelectric test voltage of 900 volts A. C., 60 cycles, bstveen 4. Assembled lampholder may ba any commerctal type complying with above requirements and bearing under- writers labratory approval. KOTES 1. 2. For design feature purposes, this standard takes precedence over procurement documents referenced Referenced documents shall be of the issue in effect on date of invitations for bid. herein. I M9 Part Numbsr (Project 625-NO84SH) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
