NEN 5453-9-1965 《对压力机气动冲压的名称》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

EN 22313-1992 en Textile Fabrics - Determination of the Recovery from Creasing of a Horizontally Folded Specimen by Measuring the Angle of Recovery《纺织品 横褶样品褶痕恢复的测定 测量复原角度法》.pdf

EN 22339-1992 en Taper Pins Unhardened《未淬硬锥销子》.pdf

EN 22340-1992 en Clevis Pins Without Head《无头U形夹销》.pdf

EN 22341-1992 en Clevis Pins with Head《有头U形夹销》.pdf

EN 22476-11-2017 en Geotechnical investigation and testing - Field testing - Part 11 Flat dilatometer test.pdf

EN 22568-1989 en Hand- and Machine-Operated Circular Screwing Dies and Hand-Operated Die Stocks《手动和机动圆板牙和手操作的板牙架(ISO 2568-1988)》.pdf

EN 22768-1-1993 en General Tolerances - Part 1 Tolerances for Linear and Angular Dimensions Without Individual Tolerance Indications《通用公差 第1部分 无单项公差标注的线性和角度尺寸公差(ISO 2768-1-1989)》.pdf

EN 22768-2-1993 en General Tolerances - Part 2 Geometrical Tolerances for Features Without Individual Tolerance Indications《通用公差 第2部分 未单独标注公差的几何公差(ISO 2768-2-1989)》.pdf

EN 22857-1989 en Ground Thread Taps for ISO Metric Threads of Tolerances 4H to 8H and 4G to 6G Coarse and Fine Pitches Manufacturing Tolerances on the Threaded Portion《ISO制螺纹公差为4H到.pdf