RTCA DO-171-1980 RECOMMENDATIONS ON POLICIES AND PROCEDURES FOR OFF-THE-SHELF ELECTRONIC TEST EQUIPMENT ACQUISITION AND SUPPORT.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

GOST 17663-1972 Units for changeable sheet stamping cutting dies with four guide posts Construction and dimensions《带四根导柱的可变薄板冲裁装置 结构和尺寸规格》.pdf

GOST 17664-1972 Clamps of units for changeable sheet stamping cutting dies Construction and dimensions《板材冲模用可换分离模组件压板 结构及尺寸》.pdf

GOST 17665-1972 Fixing devices of units for changeable sheet stamping cutting dies Construction and dimensions《可变薄板冲裁模装置的固定装置 结构和尺寸规格》.pdf

GOST 17666-1972 Ejector pins of units for changeable sheet stamping cutting dies Construction and dimensions《板材冲模用可换分离模组件的顶出器 结构及尺寸》.pdf

GOST 17667-1972 Snouts for ejector pins of units for changeable sheet stamping cutting dies Construction and dimensions《可变薄板冲裁模装置的起模杆口 结构和尺寸规格》.pdf

GOST 17668-1972 Inserts of units for changeable sheet stamping cutting dies Construction and dimensions《板材冲模用可换分离模组件的垫块 结构及尺寸》.pdf

GOST 17669-1972 Blanks of inserts of units for changeable sheet stampimg cutting dies Construction and dimensions《可变薄板冲裁模装置的镶刃刀胚 结构和尺寸规格》.pdf

GOST 17670-1972 Intermediate plates of units for changeable sheet stamping dies Construction and dimensions《板材冲模用可换分离模组件的垫板 结构及尺寸》.pdf

GOST 17671-1972 Units and set articles for changeable sheet stamping cutting dies Technical requirements《可变薄板冲裁模装置和固定用品 技术要求》.pdf