1、 AEROSPACE STANDARD PORT, RING LOCKED DESIGN STANDARD DIMENSIONS FOR MA2110Copyright 2015 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, o
2、r otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org ISSUED 1985-02REVISED 1988-02 REAFFIRMED 2015-04THIRD A
3、NGLE PROJECTION CUSTODIAN: G-3/G-3B REV.A FEDERAL SUPPLY CLASS 4730MA2110 SHEET 1 OF 2 REV. A PROCUREMENT SPECIFICATION: MA2005 (ISO 7169)SAE Technical Standards Board Rules provide that: “This report ispublished by SAE toadvance thestate of technicalandengineering sciences. Theuse ofthisreport is e
4、ntirelyvoluntary, andits applicability and suitability forany particularuse,including any patent infringement arising therefrom, isthe soleresponsibilityofthe user.”SAE reviews eachtechnicalreport at least every five years at which time itmay berevised,reaffirmed, stabilized, orcancelled. SAE invite
5、s yourwrittencomments andsuggestions. SAE values your input. To provide feedbackon this Technical Report, please visit http:/www.sae.org/technical/standards/MA2110A RATIONALE MA2110A HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE FIVE-YEAR REVIEW POLICY. AECMA interest: Future revisions of this Standard
6、 shall be coordinated with AECMA C-4.AEROSPACE STANDARD MA2110 SHEET 2 OF 2 REV. A PORT, RING LOCKED DESIGN STANDARD DIMENSIONS FOR NOTES:/1/ THREADS IN ACCORDANCE WITH AS1370 (ISO 5855)./2/ THREAD PITCH DIA AND “D” MUST BE CONCENTRIC WITHIN 0.08 FIM./3/ THREAD PITCH DIA MUST BE CONCENTRIC WITHIN 0.
7、08 FIM TO “C” DIA.4. THE DRILL AND PORTING TOOL METHOD OF PREPARING THE MACHINED CAVITY IS MANDATORY. DRILL 0.4-0.7 SMALLER THAN CONTROLLED MINOR DIA SPECIFIED. THE PORTING TOOL WILL SIZE THE MINOR DIA AND PROVIDE BALANCE OF CAVITY CONFIGURATION READY FOR BROACHING SERRATION. USE OF PREBROACH TOOL SPECIFIED IS MANDATORY TO PROVIDE PROPER SERRATIONS./5/ AFTER SERRATIONS ARE BROACHED, CHIP REMOVAL IS REQUIRED./6/ THIS PORT REQUIRES SPECIAL TOOLING FOR PROPER INSTALLATION. THIS TOOLING IS AVAILABLE FROM ROSAN PRODUCTS, 3130 W. HARVARD ST., SANTA ANA, CA. 92704.
