SIS SS-ISO 7578-1988 Road vehicles - Sheath type glow-plugs - General requirements and test methods《道路车辆 压实火花塞 一般要求和测试方法》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

GOST 13120-1983 Guide bushes smooth for cold plastic working dies Construction and dimensions《板材冲模 光滑导向衬套 结构及尺寸》.pdf

GOST 13121-1983 Guide bushes with shoulders for cold plastic working dies Construction and dimensions《低温塑料加工模用带肩导套 结构和尺寸规格》.pdf

GOST 13124-1983 Diagonal post press tool sets for cold plastic working dies Construction and dimensions《带对角导柱和衬套的板材冲模用模架 结构及尺寸》.pdf

GOST 13125-1983 Rear post press tool sets for cold plastic working dies Construction and dimensions《带后导柱和衬套的板材冲模用模架 结构及尺寸》.pdf

GOST 13126-1983 Centre post press tool sets for cold plastic working dies Construction and dimensions《带中间导柱及衬套的板材冲模用模架 结构及尺寸》.pdf

GOST 13130-1983 Post press tool sets for cold plastic working Technical requirements《低温塑料加工用导柱冲压工具 技术要求》.pdf

GOST 13133-1977 Gear grinders with profile wheel Standards of accuracy《圆柱齿轮用成型砂轮磨齿机 精度规范》.pdf

GOST 13135-1990 Surface grinders with rectangular table Basic dimensions Standards of accuracy《带矩形工作台的平面磨床 基本尺寸规格 精度标准》.pdf

GOST 13137-1982 Printers for contact printing of 16 35-and 70-mm motion picture films Exposed areas Dimensions and location Test methods《16、35和70mm影片用接触式拷贝机 曝光带的尺寸和位置 检查方法》.pdf