SNI 06-6723-2002 Specification of mineral filler for bituminous paving mixtures《矿物填料规格沥青铺路混合》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

GOST 21577-1976 Flat warp knitting machines Types main technical data and dimensions《单针平面经编机 型式尺寸》.pdf

GOST 21578-1976 Beam sections Main dimensions《平面针织机剖面梁 外形及连接尺寸》.pdf

GOST 21579-1976 Cylinder-chucking countersinks for machining parts from light alloys Design and dimensions《轻合金零件加工用圆柱柄扩孔钻 结构及尺寸》.pdf

GOST 21580-1976 End countersinks with cylinder chucking for machining parts from light alloys Design and dimensions《轻合金零件加工用圆柱柄端面扩孔钻 结构及尺寸》.pdf

GOST 21581-1976 Tapered countersinks for machining parts for light alloys Design and dimensions《轻合金零件加工用锥形柄扩孔钻 结构及尺寸》.pdf

GOST 21582-1976 End countersinks with taper chucking for machining parts from light alloys Design and dimensions《轻合金零件加工用锥形柄端面扩孔钻 结构及尺寸》.pdf

GOST 21583-1976 Tapered carbide-tipped countersinks for machining parts from lignt alloys Design and dimensions《轻合金零件加工用硬质合金锥形柄扩孔钻 结构及尺寸》.pdf

GOST 21584-1976 Shell countersinks for machining parts from light alloys Design and dimensions《轻合金零件加工用套式扩孔钻 结构及尺寸》.pdf

GOST 21585-1976 Shell carbide-tipped countersinks for machining parts from light alloys Design and dimensions《轻合金零件加工用镶硬质合金刀片套式扩孔钻》.pdf