TCVN 4683-4-2008 ISO general purpose metric screw threads Tolerances Part 4 Limits of sizes for hot-dip galvanized external screw threads to mate with internal screw threads tappedzin.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

SANS 6109-1988 Volume of gas in a cartridge《弹药筒中的气体体积》.pdf

SANS 61094-1-2009 Measurement microphones Part 1 Specifications for laboratory standard microphones《测量麦克风 第1部分 实验室标准麦克风规范》.pdf

SANS 61094-2-2009 Electroacoustics - Measurement microphones Part 2 Primary method for pressure calibration of laboratory standard microphones by the reciprocity technique《电声学 麦克风测.pdf

SANS 61094-3-2009 Measurement microphones Part 3 Primary method for free-field calibration of laboratory standard microphones by the reciprocity technique《麦克风测量 第3部分 采用互易技术校准实验室标准麦.pdf

SANS 61094-4-2009 Measurement microphones Part 4 Specifications for working standard microphones《麦克风测量 第4部分 麦克风工作标准规格》.pdf

SANS 61094-5-2009 Measurement microphones Part 5 Methods for pressure calibration of working standard microphones by comparison《麦克风测量 第5部分 采用比较方法校准麦克风工作压力标准》.pdf

SANS 61094-6-2009 Measurement microphones Part 6 Electrostatic actuators for determination of frequency response《麦克风测量 第6部分 确定频率响应的静电致动器》.pdf

SANS 6110-1988 Accumulated impact strength of ladies- shoe heels of height greater than 25 mm《高度超过25 mm的女鞋鞋跟的累积冲击强度》.pdf

SANS 61109-2008 Insulators for overhead lines - Composite suspension and tension insulators for a c systems with a nominal voltage greater than 1 000 V - Definitions test methods a.pdf