TCVN 5522-1991 Food products Method for enumeration of lactobacillus bacteria《食品 乳酸菌的计数方法》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

DIN 21772-2012 Gears - Cylindrical involute gears and gear pairs - Definition of deviations《齿轮 圆柱形渐开线齿轮和齿轮副 偏差定义》.pdf

DIN 21773-2014 Gears - Cylindrical involute gears and gear pairs - Inspection dimensions of tooth thickness《齿轮 圆柱形渐开线齿轮和齿轮副 齿厚检测尺寸》.pdf

DIN 2179-1975 Machine Taper Pin Reamers with Parallel Shanks《机用直柄锥销孔铰刀》.pdf

DIN 2180-1975 Machine Taper Pin Reamers with Morse Taper Shanks《机用带莫氏锥柄的锥销孔铰刀》.pdf

DIN 21800-1989 Symbol mallet and iron《 锤和熨斗 标志》.pdf

DIN 21802-1989 Symbols for mine rescue and gas protection squads《矿山救护分队和气体预防防护分队的标志》.pdf

DIN 2181-2015 Sets of 2 taps for metric fine ISO-threads M1 × 0 2 to M52 × 4《套装丝锥 米制ISO细螺纹M1×0 2至M52×4用两件套丝锥》.pdf

DIN 2184-1-2015 Taps and cold forming taps - Part 1 Long type General plan of dimensions《丝锥和冷成型丝锥 第1部分 长型 尺寸的一般规划》.pdf

DIN 2184-2-2003 Taps and cold forming taps - Part 2 Short type General plan of dimensions《丝锥和冷成型丝锥 第2部分 短型 尺寸的一般规划》.pdf