TS 1862-1975 LIQUIFIED PETROLEUM GASES - CYLINDER VALVES SAFETY - VALVES AND DETANDORS《液化石油气 汽缸阀、安全阀和调压器》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

DIN 8089-1979 Stub reamers《短铰刀》.pdf

DIN 8090-1981 Stub reamers with hard metal tips《硬质合金刀片的短型铰刀》.pdf

DIN 8093-1-2013 Hardmetal machine reamers with parallel shank - Part 1 Reamers with tips《硬质合金直柄铰刀 第1部分 带尖端铰刀》.pdf

DIN 8093-2-2013 Hardmetal machine reamers with parallel shank - Part 2 NC-Reamers《硬质合金直柄铰刀 第2部分 NC铰刀》.pdf

DIN 8094-1979 Machine-reamers with morse taper shank with carbide tips with long cutting part《硬质合金长切削刀片的莫氏锥柄的机器铰刀》.pdf

DIN 8096-1-1986 End mills type A for indexable inserts with parallel shanks dimensions《直柄转位式刀片 A 型端铣刀 第1部分 尺寸》.pdf

DIN 8096-2-1986 End mills type A for indexable iserts with Morse taper shanks dimensions《莫式锥柄转位式刀片 A 型端铣刀 第2部分 尺寸》.pdf

DIN 8099-1-1975 Brazed tube drawing mandrels《第1部分 铜焊管拉伸心轴》.pdf

DIN 8099-2-1975 Sleeved tube drawing mandrels《第2部分 套管拉模芯》.pdf