TS 2361-1976 Methhods for the Measurement of Air Pollution Determination of Concentration of Suspended Matter《空气污染测量方法 悬浮物浓度的测定》.pdf

相关资源

JIS A1324-1995 建筑材料中水蒸发及渗透的测量方法.pdf

JIS A1325-1995 建筑材料的热膨胀系数的测量方法.pdf

JIS A1424-1-1998 给水设施噪声的实验室试验方法.第1部分 测量方法.pdf

JIS A1431-1994 空调和通风系统的风量测量方法.pdf

JIS B5031-2003 冲压模成套模具准确度和测量方法.pdf

ANSI IEC C78.60360-2002 电灯 灯头温度升高的标准测量方法.pdf

JIS A1416-2000 声学 建筑物元件的气载声音隔绝的实验室测量方法.pdf

JIS A1520-1988 门和窗的隔声现场测量方法.pdf

JIS A8403-5-1998 土方机械.液压挖掘机.第5部分 机械过加载的测量方法.pdf

JASO D002-1991 汽车无线电干扰特性测量方法.pdf

猜你喜欢

AGMA 06FTM06-2006 An Analytical Approach to the Prediction of Micropitting on Case Carburised Gears《层渗碳齿轮微点蚀的预测分析方法》.pdf

AGMA 06FTM07-2006 Improvement of Standardized Test Methods for Evaluating the Lubricant Influence on Micropitting and Pitting Resistance of Case Carburized Gears《评估润滑剂对层渗碳齿轮上微点蚀和抗点.pdf

AGMA 06FTM08-2006 An Evaluation of FZG Micropitting Test Procedures and Results for the Crowned AGMA Test Gears《鼓形AGMA测试齿轮用FZG微点蚀测试程序和结果的评估》.pdf

AGMA 06FTM09-2006 Opportunities to Replace Wrought Gears with High Performance PM Gears in Automotive Applications《在汽车应用中用高性能PM齿轮替换精加工齿轮的时机》.pdf

AGMA 06FTM10-2006 Fabrication Assembly and Test of a High Ratio Ultra Safe High Contact Ratio Double Helical Planetary Transmission for Helicopter Applications《直升机设施用双螺旋混合行星齿轮传动高接触.pdf

AGMA 06FTM11-2006 On Tooth Failure Analysis in Small--Teeth--Number Gearing An Analytical Approach《小齿数齿轮上轮齿故障分析 分析方法》.pdf

AGMA 06FTM12-2006 A Crane Gear Failure Analysis -- Case Study Observations Lessons Learned Recommendations《起重机齿轮疲劳分析.案例研究、观察、课程学习、介绍》.pdf

AGMA 06FTM13-2006 Economic Aspects of Vacuum Carburizing《真空渗碳处理的经济性》.pdf

AGMA 06FTM14-2006 The Optimal High Speed Cutting of Bevel Gears -- New Tools and New Cutting Parameters《锥齿轮的最佳高速切割.新工具和新切割参数》.pdf