TS 2486-1976 Sodium Fluoride for Industrial Use Determination of Water-Insoluble Matter《工业用氟化钠 水不溶解物的测定》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

BS EN 985-2001 Textile floor coverings - Castor chair test《铺地织物 小脚轮轮椅试验》.pdf

BS EN 986-2005 Textile floor coverings - Tiles - Determination of dimensional changes due to the effects of varied water and heat conditions and distortion out of plane《铺地织物 铺地织物块 .pdf

BS EN 988-1997 Zinc and zinc alloys - Specification for rolled flat products for building《锌和锌合金 建筑用轧制平板材规格》.pdf

BS EN 989-1996 Determination of the bond behaviour between reinforcing bars and autoclaved aerated concrete by the push-out test《采用推挤试验法测定增强棒材和热压充气混凝土胶合力》.pdf

BS EN 990-2002 Test methods for verification of corrosion protection of reinforcement in autoclaved aerated concrete and lightweight aggregate concrete with open structure《热压充气混凝土和.pdf

BS EN 991-1996 Determination of the dimensions of prefabricated reinforced components made of autoclaved aerated concrete or lightweight aggregate concrete with open structure《采用热压.pdf

BS EN 992-1996 Determination of the dry density of lightweight aggregate concrete with open structure《开放结构轻型聚集式混凝土干燥密度的测定》.pdf

BS EN 993-1-1995 Methods of test for dense shaped refractory products - Determination of bulk density apparent porosity and true porosity《致密成型耐火制品的试验方法 松密度 表观孔隙度和实际孔隙度的测定》.pdf

BS EN 993-10-1998 Methods of test for dense shaped refractory products - Determination of permanent change in dimensions on heating《成形密实耐火制品的试验方法 受热时尺寸规格永久变化的测定》.pdf