TS 3462-1980 Particle boards (Veneered flatpressed)《刨花板（平压薄板）》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

TCVN 7009-1-2002 Anaesthesia and respiratory care alarm signals Part 1 Visual alarm signals《麻醉和呼吸护理报警信号 第1部分 视觉报警信号》.pdf

TCVN 7009-2-2002 Anaesthesia and respiratory care alarm signals Part 2 Auditory alarm signals《麻醉和呼吸护理报警信号 第2部分 听觉报警信号》.pdf

TCVN 7009-3-2002 Anaesthesia and respiratory care alarm signals Part 3 Guidance on application of alarms《麻醉和呼吸护理报警信号 第3部分 报警应用指南》.pdf

TCVN 7010-2-2007 Lung ventilators for medical use Particular requirements for basic safety and essential performance Part 2 Home care ventilators for ventilator-dependent patients《.pdf

TCVN 7011-1-2007 Test code for machine tools Part 1 Geometric accuracy of machines operating under no-load or finishing conditions《机床试验规程 第1部分 在空载或精加工条件下机床运行的几何精度》.pdf

TCVN 7011-2-2007 Test code for machine tools - Part 2 Determination of accuracy and repeatability of positioning numerically controlled axes《机床试验规程 第2部分 数控轴定位精度和可重复性测定》.pdf

TCVN 7011-3-2007 Test code for machine tools - Part 3 Determination of thermal effects《机床试验规程 第3部分 热效应的测定》.pdf

TCVN 7011-4-2013 Test code for machine tools Part 4 Circular tests for numerically controlled machine tools《机床试验规程 第4部分 数控机床的圆弧检验》.pdf

TCVN 7011-5-2007 Test code for machine tools Part 5 Determination of the noise emission《机床试验规程 第5部分 噪声排放的测定》.pdf