1、08-11 01 58 16 - 1 SECTION 01 58 16 TEMPORARY INTERIOR SIGNAGE PART 1 GENERAL DESCRIPTION This section specifies temporary interior signs. PART 2 PRODUCTS 2.1 TEMPORARY SIGNS A. Fabricate from 50 Kg (110 pound) mat finish white paper. B. Cut to 100 mm (4-inch) wide by 300 mm (12 inch) long size tag.
2、 C. Punch 3 mm (1/8-inch) diameter hole centered on 100 mm (4-inch) dimension of tag. Edge of Hole spaced approximately 13 mm (1/2-inch) from one end on tag. D. Reinforce hole on both sides with gummed cloth washer or other suitable material capable of preventing tie pulling through paper edge. E. T
3、ies: Steel wire 0.3 mm (0.0120-inch) thick, attach to tag with twist tie, leaving 150 mm (6-inch) long free ends. PART 3 EXECUTION 3.1 INSTALLATION A. Install temporary signs attached to room door frame or room door knob, lever, or pull for doors on corridor openings. B. Mark on signs with felt tip
4、marker having approximately 3 mm (1/8-inch) wide stroke for clearly legible numbers or letters. C. Identify room with numbers as designated on floor plans. 3.2 LOCATION A. Install on doors that have room, corridor, and space numbers shown. B. Doors that do not require signs are as follows: 1. Corrid
5、or barrier doors (cross-corridor) in corridor with same number. 2. Folding doors or partitions. 3. Toilet or bathroom doors within and between rooms. 4. Communicating doors in partitions between rooms with corridor entrance doors. 5. Closet doors within rooms. C. Replace missing, damaged, or illegible signs. - - - E N D - - - Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
