CNS 739-1993 Method of Test for Rubber Inner Tubes for Bicycles《自行车用橡胶内胎检验法》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

HB 6835-1993 数控机床用六齿削平型直柄立铣刀 d=16~50mm.pdf

HB 6836-1993 数控机床用三齿莫氏锥柄立铣刀 d=14~28mm.pdf

HB 6837-1993 数控机床用三齿端刃过中心莫氏锥柄立铣刀 d=14~28mm.pdf

HB 6838-1993 数控机床用四齿莫氏锥柄立铣刀 d=14~50mm.pdf

HB 6839-1993 数控机床用六齿莫氏锥柄立铣刀 d=22~63mm.pdf

HB 6840-1993 数控机床用普通立铣刀技术条件.pdf

HB 6841-1993 塑料模具型腔表面粗糙度样块和塑料样板技术要求及评定方法.pdf

HB 6842-1993 LC4板材和型材零件的成形.pdf

HB 6852-1993 螺栓最小抗拉强度为1075MPa用预载垫圈.pdf