MNOSZ 14415-1953 《金属打磨机床的半径铣床移动概念》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

KS M ISO 4435-2008 Unplasticized poly(vinyl chloride)(PVC-U) pipes and fittings for buried drainage and sewerage systems－Specifications《地下排水和排污水用塑料管道系统 未增塑聚氯乙烯》.pdf

KS M ISO 456-2007 Surface active agents－Analysis of soaps－Determination of free caustic alkali《表面活性剂 肥皂分析 游离苛性碱的测定》.pdf

KS M ISO 4578-2009 Adhesives－Determination of peel resistance of high-strength adhesive bonds－Floating-roller method《粘合剂 高强度黏合抗剥离性的测定 浮辊法》.pdf

KS M ISO 458-1-2007 Plastics－Determination of stiffness in torsion of flexible materials－Part 1：General method《塑料 可弯曲材料的扭曲刚度的测定 第1部分 一般方法》.pdf

KS M ISO 4582-2012 Plastics-Determination of changes in colour and variations in properties after exposure to daylight under glass natural weathering or laboratory light sources《塑料.pdf

KS M ISO 4590-2010 Rigid cellular plastics－Determination of the volume percentage of open cells and of closed cells《硬质泡沫塑料 开口和封闭气室容积百分数测定》.pdf

KS M ISO 4591-2007 Plastics-Film and sheeting-Determiantion of average thickness of a sample and average thickness and yield of a roll by gravimetric techniques(gravimetric thickne.pdf

KS M ISO 4592-2007 Plastics－Film and sheeting－Determination of length and width《塑料 薄片和薄膜 长度和宽度的测定》.pdf

KS M ISO 4611-2012 Plastics－Determination of the effects of exposure to damp heat water spray and salt mist《塑料 湿热、水溅和盐雾效应的测定》.pdf