1、BS ISO 6668:2008 ICS 67.140.20; 67.240 NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW BRITISH STANDARD Green coffee Preparation of samples for use in sensory analysisThis British Standard was published under the authority of the Standards Policy and Strategy Committee on 31 J
2、uly 2008 BSI 2008 ISBN 978 0 580 57347 7 Amendments/corrigenda issued since publication Date Comments BS ISO 6668:2008 National foreword This British Standard is the UK implementation of ISO 6668:2008. It supersedes BS 6379-4:1991 which is withdrawn. The UK participation in its preparation was entru
3、sted to Technical Committee AW/15, Coffee. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a
4、British Standard cannot confer immunity from legal obligations.BS ISO 6668:2008Reference number ISO 6668:2008(E) ISO 2008INTERNATIONAL STANDARD ISO 6668 Second edition 2008-06-01 Green coffee Preparation of samples for use in sensory analysis Caf vert Prparation des chantillons en vue de lanalyse se
5、nsorielle BS ISO 6668:2008 ISO 6668:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer perfor
6、ming the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF
7、 file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Se
8、cretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT ISO 2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in wr
9、iting from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2008 All rights reservedBS ISO 6
10、668:2008 ISO 6668:2008(E) ISO 2008 All rights reserved iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committ
11、ees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the Int
12、ernational Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International
13、Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the s
14、ubject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 6668 was prepared by Technical Committee ISO/TC 34, Food products, Subcommittee SC 15, Coffee. This second edition cancels and replaces the first edition (ISO 6668:1991), which has been tech
15、nically revised. It also incorporates the Technical Corrigendum ISO 6668:1991/Cor.1:2000. BS ISO 6668:2008BS ISO 6668:2008 INTERNATIONAL STANDARD ISO 6668:2008(E) ISO 2008 All rights reserved 1 Green coffee Preparation of samples for use in sensory analysis 1 Scope This International Standard specif
16、ies a method for the roasting of green coffee, grinding the roasted coffee, and the preparation from the ground coffee of a beverage to be used in sensory analysis. The sensory analysis carried out following this preparation may be used to determine the acceptance or rejection of a shipment of coffe
17、e, subject to agreement between the parties concerned. Generally, the sample will require a light roast for assessment of defects, and a medium roast for assessment of flavour and colour. A beverage prepared in accordance with this International Standard can be used not only for purposes of quality
18、control, but also for purposes of comparative assessment of different samples, in which case an identical procedure can be followed for each of the samples. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only th
19、e edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 565, Test sieves Metal wire cloth, perforated metal plate and electroformed sheet Nominal sizes of openings ISO 3696, Water for analytical laboratory use Specificati
20、on and test methods ISO 4072, Green coffee in bags Sampling 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 beverage solution prepared by the extraction of soluble substances from roast and ground coffee, using freshly boiled water, under the
21、 conditions specified in this International Standard 3.2 roasted ground coffee roast and ground coffee R b) the method used, including reference to this International Standard; c) the roasting temperature and roasting time applied; d) all operating details not specified in this International Standar
22、d or regarded as optional, together with details of any incidents which may have influenced the beverage quality with respect to its sensory properties. BS ISO 6668:2008BS ISO 6668:2008 ISO 6668:2008(E) ICS 67.140.20; 67.240 Price based on 4 pages ISO 2008 All rights reserved BS ISO 6668:2008 This p
23、age has been intentionally left blankBS ISO 6668:2008 BSI Group Headquarters 389 Chiswick High Road, London, W4 4AL, UK Tel +44 (0)20 8996 9001 Fax +44 (0)20 8996 7001 standards BSI - British Standards Institution BSI is the independent national body responsible for preparing British Standards. It
24、presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions British Standards are updated by amendment or revision. Users of British Standards should make sure that they possess the latest amendments or editions. It is the constant aim o
25、f BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this British Standard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel: +44 (0)
26、20 8996 9000. Fax: +44 (0)20 8996 7400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically receive the latest editions of standards. Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Cu
27、stomer Services. Tel: +44 (0)20 8996 9001. Fax: +44 (0)20 8996 7001 Email: You may also buy directly using a debit/credit card from the BSI Shop on the Website http:/ In response to orders for international standards, it is BSI policy to supply the BSI implementation of those that have been publish
28、ed as British Standards, unless otherwise requested. Information on standards BSI provides a wide range of information on national, European and international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available whi
29、ch give details on all its products and services. Contact Information Centre. Tel: +44 (0)20 8996 7111 Fax: +44 (0)20 8996 7048 Email: Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of thes
30、e and other benefits contact Membership Administration. Tel: +44 (0)20 8996 7002 Fax: +44 (0)20 8996 7001 Email: Information regarding online access to British Standards via British Standards Online can be found at http:/ Further information about BSI is available on the BSI website at http:/ Copy
31、right Copyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of the publications of the international standardization bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted
32、in any form or by any means electronic, photocopying, recording or otherwise without prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. Details and advice can be obtained from the Copyright and Licensing Manager. Tel: +44 (0)20 8996 7070 Email:
