1、BSI Standards Publication BS ISO/IEC/IEEE 18881:2016 Information technology Ubiquitous green community control network Control and managementBS ISO/IEC/IEEE 18881:2016 BRITISH STANDARD National foreword This British Standard is the UK implementation of ISO/IEC/IEEE 18881:2016. The UK participation i
2、n its preparation was entrusted to Technical Committee IST/6, Data communications. A list of organizations represented on this committee can be obtained on request to its secretary. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its
3、 correct application. The British Standards Institution 2016. Published by BSI Standards Limited 2016 ISBN 978 0 580 92013 4 ICS 35.110 Compliance with a British Standard cannot confer immunity from legal obligations. This British Standard was published under the authority of the Standards Policy an
4、d Strategy Committee on 30 April 2016. Amendments/corrigenda issued since publication Date Text affectedBS ISO/IEC/IEEE 18881:2016 Reference number ISO/IEC/IEEE 18881:2016(E) IEEE 2013 INTERNATIONAL STANDARD ISO/IEC/ IEEE 18881 First edition 2016-04-15 Information technology Ubiquitous green communi
5、ty control network Control and management Technologies de linformation Protocole de contrle de la communaut verte omniprsente Contrle et gestionBS ISO/IEC/IEEE 18881:2016 ISO/IEC/IEEE 18881:2016(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing polic
6、y, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. Neither the ISO C
7、entral Secretariat nor IEEE accepts any liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care
8、 has been taken to ensure that the file is suitable for use by ISO member bodies and IEEE members. In the unlikely event that a problem relating to it is found, please inform the ISO Central Secretariat or IEEE at the address given below. COPYRIGHT PROTECTED DOCUMENT IEEE 2013 All rights reserved. U
9、nless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from ISO, IEC or IEEE at the respective address below. ISO copyright office Case postale 56
10、CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 IEC Central Office Institute of Electrical and 3, rue de Varemb Electronics Engineers, Inc. CH-1211 Geneva 20 3 Park Avenue, New York Switzerland NY 10016-5997, USA E-mail inmailiec.ch E-mail stds.iprieee.org Web www.iec.ch Web www.ieee.
11、org E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii IEEE 2013 All rights reservedBS ISO/IEC/IEEE 18881:2016 ISO/IEC/IEEE 18881:2016(E) IEEE 2013 All rights reserved iii Foreword ISO (the International Organization for Standardization) and IEC (the International Electrotechnical C
12、ommission) form the specialized system for worldwide standardization. National bodies that are members of ISO or IEC participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity.
13、 ISO and IEC technical committees collaborate in fields of mutual interest. Other international organizations, governmental and non- governmental, in liaison with ISO and IEC, also take part in the work. In the field of information technology, ISO and IEC have established a joint technical committee
14、, ISO/IEC JTC 1. IEEE Standards documents are developed within the IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association (IEEE-SA) Standards Board. The IEEE develops its standards through a consensus development process, approved by the American National Standard
15、s Institute, which brings together volunteers representing varied viewpoints and interests to achieve the final product. Volunteers are not necessarily members of the Institute and serve without compensation. While the IEEE administers the process and establishes rules to promote fairness in the con
16、sensus development process, the IEEE does not independently evaluate, test, or verify the accuracy of any of the information contained in its standards. The main task of ISO/IEC JTC 1 is to prepare International Standards. Draft International Standards adopted by the joint technical committee are ci
17、rculated to national bodies for voting. Publication as an International Standard requires approval by at least 75 % of the national bodies casting a vote. Attention is called to the possibility that implementation of this standard may require the use of subject matter covered by patent rights. By pu
18、blication of this standard, no position is taken with respect to the existence or validity of any patent rights in connection therewith. ISO/IEEE is not responsible for identifying essential patents or patent claims for which a license may be required, for conducting inquiries into the legal validit
19、y or scope of patents or patent claims or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance or a Patent Statement and Licensing Declaration Form, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of
20、this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from ISO or the IEEE Standards Association. ISO/IEC/IEEE 18881 was prepared by the Corpo
21、rate Advisory Group of the IEEE-SA Board of Governors (as IEEE 1888.1-2013). It was adopted by Joint Technical Committee ISO/IEC JTC 1, Information technology, Subcommittee SC 6, Telecommunications and information exchange between systems, in parallel with its approval by the ISO/IEC national bodies
22、, under the “fast-track procedure” defined in the Partner Standards Development Organization cooperation agreement between ISO and IEEE. IEEE is responsible for the maintenance of this document with participation and input from ISO/IEC national bodies. BS ISO/IEC/IEEE 18881:2016 BS ISO/IEC/IEEE 1888
23、1:2016 IEEE Standard for Ubiquitous Green Community Control Network: Control and Management Sponsored by the Corporate Advisory Group IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE-SA Board of Governors IEEE Std 1888.1-2013 BS ISO/IEC/IEEE 18881:2016 IEEE Standard for Ubiquitous Green Community
24、 Control Network: Control and Management Sponsored by the Corporate Advisory Group IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE-SA Board of Governors IEEE Std 1888.1-2013 BS ISO/IEC/IEEE 18881:2016 BS ISO/IEC/IEEE 18881:2016 IEEE Standard for Ubiquitous Green Community Control Network: Contro
25、l and Management Sponsor Corporate Advisory Group of the IEEE-SA Board of Governors Approved 23 August 2013 IEEE-SA Standards Board IEEE 2013 All rights reserved ISO/IEC/IEEE 18881:2016(E) IEEE Std 1888.1-2013 BS ISO/IEC/IEEE 18881:2016 BS ISO/IEC/IEEE 18881:2016 IEEE Standard for Ubiquitous Green C
26、ommunity Control Network: Control and Management Sponsor Corporate Advisory Group of the IEEE-SA Board of Governors Approved 23 August 2013 IEEE-SA Standards Board IEEE 2013 All rights reserved ISO/IEC/IEEE 18881:2016(E) IEEE Std 1888.1-2013 BS ISO/IEC/IEEE 18881:2016 ISO/IEC/IEEE 18881:2016(E) IEEE
27、 Std 1888.1-2013BS ISO/IEC/IEEE 18881:2016 The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2013 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 11 October 2013. Printed in the United State
28、s of America. IEEE is a registered trademark in the U.S. Patent specifies control and management requirements; defines the system architecture, communication sequences, and enhanced functions for the protocols defined in IEEE 1888, “Ubiquitous Green Community Control Network Protocol”; and extends t
29、he protocols and interfaces based on the requirements. This standard shall provide enhanced protocols, workflows, and message formats for the network gateway under control and management, such as registration, access, control, event handling, configuration, status querying, etc. Keywords: access, co
30、nfiguration, control, event handling, IEEE 1888.1, management, running status BS ISO/IEC/IEEE 18881:2016 Notice and Disclaimer of Liability Concerning the Use of IEEE Documents: IEEE Standards documents are developed within the IEEE Societies and the Standards Coordinating Committees of the IEEE Sta
31、ndards Association (IEEE-SA) Standards Board. IEEE develops its standards through a consensus development process, approved by the American National Standards Institute, which brings together volunteers representing varied viewpoints and interests to achieve the final product. Volunteers are not nec
32、essarily members of the Institute and serve without compensation. While IEEE administers the process and establishes rules to promote fairness in the consensus development process, IEEE does not independently evaluate, test, or verify the accuracy of any of the information or the soundness of any ju
33、dgments contained in its standards. Use of an IEEE Standard is wholly voluntary. IEEE disclaims liability for any personal injury, property or other damage, of any nature whatsoever, whether special, indirect, consequential, or compensatory, directly or indirectly resulting from the publication, use
34、 of, or reliance upon any IEEE Standard document. IEEE does not warrant or represent the accuracy or content of the material contained in its standards, and expressly disclaim s any express or implied warranty, including any implied warranty of merchantability or fitness for a specific purpose, or t
35、hat the use of the material contained in its standards is free from patent infringement. IEEE Standards documents are supplied “ AS IS.“ The existence of an IEEE Standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services rela
36、ted to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. Every IEEE standard is subjected to review at le
37、ast every ten years. When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have t he la
38、test edition of any IEEE standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity. Nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person ut
39、ilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. Translations: The IEEE
40、consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official Statements: A statement, written or oral, that is not processed in ac
41、cordance with the IEEE-SA Standards Board Operations Manual shall not be considered the official position of IEEE or any of its committees and shall not be considered to be, nor be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual prese
42、nting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on Standards: Comments for revision of IEEE Standards documents are welcome from any interested party, regardless
43、 of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards r
44、epresent a consensus of concerned interests, it is important to ensure that any responses to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant
45、response to comments or questions except in those cases where the matter has previously been addressed. Any person who would like to participate in evaluating comments or revisions to an IEEE standard is welcome to join the relevant IEEE working group at http:/standards.ieee.org/develop/wg/. Comment
46、s on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Photocopies: Authorization to photocopy portions of any individual standard for internal or personal use is granted by The Institute of Electrical and Electronics En
47、gineers, Inc., provided that the appropriate fee is paid to Copyright Clearance Center. To arrange for payment of licensing fee, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual
48、 standard for educational classroom use can also be obtained through the Copyright Clearance Center. IEEE 2013 All rights reserved ISO/IEC/IEEE 18881:2016(E) BS ISO/IEC/IEEE 18881:2016 ISO/IEC/IEEE 18881:2016(E)BS ISO/IEC/IEEE 18881:2016 The Institute of Electrical and Electronics Engineers, Inc. 3
49、Park Avenue, New York, NY 10016-5997, USA Copyright 2013 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 11 October 2013. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent specifies control and management requirements; defines the system architecture, communication sequences, and enhanced functions for the protocols defined in IEEE 1888, “Ubiquitous Green Community Control Network Protocol”; and extends the protocols and interfaces based on the
