1、AECMA STANDARD NORME AECMA AECMA NORM Edition approved for publication 14 March 2003 prEN 3841-405 Edition P 3 March 2003 Comments should be sent within six months after the date of publication to Electrical Domain AECMA-STAN ICs: 49.060 Descriptors: ENGLISH VERSION Aerospace series Circuit breakers
2、 Test methods Part 405: Fluid resistance Supersedes edition P 2 September 1998 Srie arospatiale Disjoncteurs Mthodes dessais Partie 405 : Rsistance aux fluides Luft- und Raumfahrt Schutzschalter Prfverfahren Teil 405: Bestndigkeit gegen Flssigkeiten This “Aerospace Series“ Prestandard has been drawn
3、 up under the responsibility of AECMA-STAN (The European Association of Aerospace Industries - Standardization). It is published on green paper for the needs of the European Aerospace Industry. It has been technically approved by the experts of the concerned Domain following member comments. Subsequ
4、ent to the publication of this Prestandard, the technical content shall not be changed to an extent that interchangeability is affected, physically or functionally, without re-identification of the standard. After examination and review by users and formal agreement of AECMA-STAN it will be submitte
5、d as a draft European Standard to CEN (European Committee for Standardization) for formal vote. Copyright Association Europeene des Constructeurs de Materiel Aerospatial Provided by IHS under license with AECMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Page 2
6、prEN 3841-405: 2003 Foreword This standard was reviewed by the Domain Technical Coordinator of AECMA-STANS Electrical Domain. After inquiries and votes carried out in accordance with the rules of AECMA-STAN defined in AECMA- STANS General Process Manual, this standard has received approval for Publi
7、cation. Copyright Association Europeene des Constructeurs de Materiel Aerospatial Provided by IHS under license with AECMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Page 3 prEN 3841-405: 2003 1 Scope This standard specifies a method of verifying the circuit br
8、eakers ability to withstand fluids as defined in EN 3909. It shall be used together with EN 3841-100. 2 Normative references This European Standard incorporates by dated or undated reference provisions from other publications. These normative references are cited at the appropriate places in the tex
9、t and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applie
10、s. EN 3841-100, EN 3909, Aerospace series - Circuit breakers - Test methods - Patt 700: General 1) Aerospace series - Test fluids for electric components and sub-assemblies 1) 3 Method 3.1 Mounting The circuit breakers shall be submitted to the test in the closed position. 3.2 Procedure One circuit
11、breaker shall be used for each fluid as defined in EN 3909 and wetted using a brush. The circuit breakers shall remain wet for 24 h at ambient temperature except for the fire extinguishing agent. 3.3 Requirement Manual verification of the mechanical function after wetting; then, after the drying pha
12、se the tests in accordance with technical specification and product standard shall be carried out. The current rating marking shall still be legible. A change in colour and of the other markings is acceptable. 1) Published as AECMA Prestandard at the date of publication of this standard Copyright Association Europeene des Constructeurs de Materiel Aerospatial Provided by IHS under license with AECMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
