1、INCH-POUND MIL-DTL-3628/250 31 October 2008 DETAIL SPECIFICATION SHEET BADGE, IDENTIFICATION, UNITED STATES AFRICA COMMAND This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of
2、 this specification sheet and the latest issue of MIL-DTL-3628. MATERIAL: Gilding Metal FINISH: Nickel plated, Mirror-like Polished and shall match The Institute of Heraldry (TIOH) Metal Finish Chip Number 16. DIMENSIONS: HEIGHT: 2 inch (REF) WIDTH: 1-5/8 inch (REF) THICKNESS (at thickest point): 0.
3、080 inches .01 inches AMSC N/A Page 1 of 2 FSC 8455 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-3628/250 Page 2 of 2 NOTES: 1. The term (REF) refers to the measurements taken from the Government furnished hub or die. 2. Attaching device s
4、hall be prong and flat ball clutch type. Two prongs shall be located on the reverse on the vertical center line located equidistant from each end 1-1/2 inches 1/8 inch apart. 3. All color areas shall be as indicated and shall be enamel/epoxy. Colors will conform to (TIOH) Hard Enamel Chip Numbers li
5、sted below. COLOR CHIP NUMBER Red 1 Green 12 Blue 18 Bluebird 33 Custodian: Preparing activity: Army - IH Army - IH Air Force -11 (Project No. 8455-2009-001) Navy - NU Review activities: Air Force - 99 Navy - MC DLA - CT NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
