1、AMSC N/A Page 1 of 7 FSC 6135 DISTRIBUTION STATEMENT A: Approved for public release; distribution is unlimited INCH-POUND MIL-PRF-32271/13 30 October 2008 PERFORMANCE SPECIFICATION SHEET BATTERY, NON-RECHARGEABLE, LITHIUM This specification is approved for use by all Departments and Agencies of the
2、Department of Defense. The requirements for acquiring the product herein shall consist of this specification and MIL-PRF-32271. Figure 1 General View, M32271/13 Battery Shape REQUIREMENTS (see 1.2 for Type, Class, and Features descriptions): Type - I Type - II Type - III Class - 2 Class - 2 Class -
3、2 Features - C Features - C Features - C PIN: M32271/13-12C PIN: M32271/13-22C PIN: M32271/13-32C Approved Chemistry: Lithium manganese dioxide Approved Chemistry: Lithium sulfur dioxide Approved Chemistry: Lithium manganese dioxide Specification requirements: The following requirements of MIL-PRF-3
4、2271, identified therein as “when specified”, are applicable as indicated below: See NOTES for nominal dimensions; see applicable drawing for dimensional requirementsCopyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking perm
5、itted without license from IHS-,-,-MIL-PRF-32271/13 2 Requirement Specification Reference Applicability Types I Type II 1.0 lbs. (454 g); Type III 1.6 lbs. (726 g) Capacity test requirements (3.6 Type II 6.2 ampere-hours; Type III 10.8 ampere-hours. Copyright Communications - Electronics Command Pro
6、vided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-32271/13 4 METHODS OF EXAMINATION AND TEST: Verification requirements. The following verification requirements of MIL-PRF-32271, identified therein by the phrase “when speci
7、fied,” are applicable as indicated below: Test Requirement Specification Reference Applicability Types I 1.7 hours for Type II batteries; 2.9 hours for Type III batteries. Abuse test, pulse discharge: When tested as specified in 4.6.2.12i, discharge with a load of 2.5 amperes for 1 minute followed b
8、y 1.8 amperes for 4 minutes, cycled continuously to 6.0 volts. Battery over-current protection: When tested as specified in 4.6.2.13, load batteries with either 4 amperes or 20 watts. 4This test only required if parallel cell arrangements are used Copyright Communications - Electronics Command Provi
9、ded by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-32271/13 5 Immersion: When tested as specified in 4.6.5.8, apply a load of 1.2 amperes during the storage and immersion time periods specified. Capacity tests (4.6.4): Test Di
10、scharge Rate Duty Cycle I 2.0 amperes Continuous discharge to cut-off volts, followed by 2.0 amperes To zero volts, then 2.0 amperes forced discharge for 5 minutes. L 2.0 amperes Continuous discharge to cut-off voltage H 2.0 amperes Discharge for 5 minutes at 2 amperes, followed by 5 minutes on open
11、 circuit; repeat cycle continuously to cut-off voltage LR 135 mA/1.7W Continuous discharge at 135 milli-amperes to 6.5 volts, then Discharge at 1.7 watts to cut-off voltage IT 2.0 amperes Continuous discharge to cut-off voltage LT 2.0 amperes Continuous discharge to cut-off voltage HT 2.0 amperes Di
12、scharge for 5 minutes at 2 amperes, followed by 5 minutes on open circuit; repeat cycle continuously to cut-off voltage LRT 135 mA/1.7W Continuous discharge at 135 milli-amperes to 6.5 volts, then Discharge at 1.7 watts to cut-off voltage NOTES: (This section contains information of a general nature
13、 which may be helpful, but is not mandatory) Intended use: This battery is intended for use in digital communications terminals. It is also used to power some test sets. 5Nominal ratings: The following are the nominal ratings for the battery described by this specification sheet. They are provided f
14、or information purposes. 5Capacity and energy delivered by a battery are significantly affected by usage conditions, such as temperature and loads applied. If you have any questions about use of this battery in a particular device or circumstance, please visit the following web site (contact info is
15、 posted): http:/www.cerdec.army.mil/c2d/armypower. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-32271/13 6 Battery PIN: M32271/13-12C M32271/13-22C M32271/13-32C Overal
16、l Dimensions: 2.5 in. H x 6.0 in. W x 1.5 in. D MAX Weight: 1.5 lbs (680 grams) 1.0 lbs (454 grams) 1.6 lbs (726 grams) Voltage Range: 6.0-9.9 6.0-9.15 6.0-9.9 Nominal Capacity (Ampere-hours): 10 Amp-hrs 6.8 Amp-hrs 11.6 Amp-hrs Nominal Energy (Watt-hours): 78 Watt-hrs 53 Watt-hrs 90 Watt-hours MAX
17、Rated Power Output: 23 Watts MAX Continuous Load Rating: 2.0 Amperes MAX Pulse Rating: 2.5 Amperes Instantaneous Trip Rating: 4.0 Amperes Operating Temperature Range: -20 to 130F (-29 to 55C) -4 to 130F (-20 to 55C) Storage Temperature Range: -40 to 160F (-40 to 71C) MAX Abusive Temperature (non-ope
18、rating): 195F (91C) 172F (78C) Other data: Military Type Designations. The military type designations that relate to the PINs covered by this specification sheet are as follows: The BA-5399()/U designation has been used for the Type I PIN; the BA-5599()/U designation has been used for the Type II PI
19、N; and the BA-7599()/U designation was considered for prototypes of the Type III PIN. All battery types covered by this specification sheet are subject to the transportation requirements of 49 CFR 173.185. Types I type II has liquid cathodes and more than 1.0 grams of lithium. See applicable Materia
20、l Safety Data Sheet (MSDS) for the maximum lithium weight per cell and battery. It should be noted that all non-rechargeable lithium batteries are restricted from shipment as cargo aboard passenger aircraft within, entering, or leaving the US. All battery types include a complete discharge device in
21、 order to render the battery non-reactive after use. If a battery is damaged, or if the device does not operate as indicated by an amber or yellow light, the battery is considered reactive waste. This battery may be recycled after use. Universal waste rules, where applicable, apply only when recycli
22、ng is the chosen disposal method. The US Army CECOM Life Cycle Management Command (LCMC) publishes guidelines for the design of battery compartments for devices using the types I & II batteries covered by this specification sheet: Technical Bulletin CECOM-TB-7. Please contact the CECOM LCMC Director
23、ate for Safety at monm-amselsfsecconus.army.mil for further information. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-32271/13 7 Navy safety tests of NAVSEA S9310-AQ-SA
24、F-010 are required for this battery during first article testing. The test data provided from the testing will be used to evaluate applications for specific using devices and Navy platforms. Devices using either battery will require US Navy Safety Approval prior to use by Department of Navy users un
25、less such approval has already been granted. Please consult with NAVSEA Instruction 9310.1 for further information. Custodians: Preparing activity: Army CR Army CR Navy NW (Project Number 6135-2006-016) Air Force 99 DLA GS Review activities: Navy SH, AS, MC Air Force 71 NOTE: The activities listed a
26、bove were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil or http:/assist.daps.dla.mil/quicksearch/. Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
