1、ANSI/ASHRAE/ASHE Addendum b toANSI/ASHRAE/ASHE Standard 170-2013Ventilation ofHealth Care FacilitiesApproved by the ASHRAE Standards Committee on June 28, 2014; by the ASHRAE Board of Directors on July 2, 2014; by theASHE Board of Directors on May 15, 2014; and by the American National Standards Ins
2、titute on July 3, 2014.This addendum was approved by a Standing Standard Project Committee (SSPC) for which the Standards Committee has estab-lished a documented program for regular publication of addenda or revisions, including procedures for timely, documented, con-sensus action on requests for ch
3、ange to any part of the standard. The change submittal form, instructions, and deadlines may beobtained in electronic form from the ASHRAE website (www.ashrae.org) or in paper form from the Manager of Standards. The latest edition of an ASHRAE Standard may be purchased on the ASHRAE website (www.ash
4、rae.org) or from ASHRAE Cus-tomer Service, 1791 Tullie Circle, NE, Atlanta, GA 30329-2305. E-mail: ordersashrae.org. Fax: 678-539-2129. Telephone: 404-636-8400 (worldwide), or toll free 1-800-527-4723 (for orders in US and Canada). For reprint permission, go towww.ashrae.org/permissions. 2014 ASHRAE
5、 ISSN 1041-2336SPECIAL NOTEThis American National Standard (ANS) is a national voluntary consensus standard developed under the auspices of ASHRAE.Consensus is defined by the American National Standards Institute (ANSI), of which ASHRAE is a member and which has approved thisstandard as an ANS, as “
6、substantial agreement reached by directly and materially affected interest categories. This signifies the concurrenceof more than a simple majority, but not necessarily unanimity. Consensus requires that all views and objections be considered, and that aneffort be made toward their resolution.” Comp
7、liance with this standard is voluntary until and unless a legal jurisdiction makes compliancemandatory through legislation.ASHRAE obtains consensus through participation of its national and international members, associated societies, and public review.ASHRAE Standards are prepared by a Project Comm
8、ittee appointed specifically for the purpose of writing the Standard. The ProjectCommittee Chair and Vice-Chair must be members of ASHRAE; while other committee members may or may not be ASHRAE members, allmust be technically qualified in the subject area of the Standard. Every effort is made to bal
9、ance the concerned interests on all ProjectCommittees.The Manager of Standards of ASHRAE should be contacted for:a. interpretation of the contents of this Standard,b. participation in the next review of the Standard,c. offering constructive criticism for improving the Standard, ord. permission to re
10、print portions of the Standard.DISCLAIMERASHRAE uses its best efforts to promulgate Standards and Guidelines for the benefit of the public in light of available information andaccepted industry practices. However, ASHRAE does not guarantee, certify, or assure the safety or performance of any product
11、s, components,or systems tested, installed, or operated in accordance with ASHRAEs Standards or Guidelines or that any tests conducted under itsStandards or Guidelines will be nonhazardous or free from risk.ASHRAE INDUSTRIAL ADVERTISING POLICY ON STANDARDSASHRAE Standards and Guidelines are establis
12、hed to assist industry and the public by offering a uniform method of testing for ratingpurposes, by suggesting safe practices in designing and installing equipment, by providing proper definitions of this equipment, and by providingother information that may serve to guide the industry.The creation
13、 of ASHRAE Standards and Guidelines is determined by the need for them,and conformance to them is completely voluntary.In referring to this Standard or Guideline and in marking of equipment and in advertising, no claim shall be made, either stated or implied,that the product has been approved by ASH
14、RAE.ASHRAE Standing Standard Project Committee 170CognizantTC:TC 9.6, Healthcare FacilitiesSPLS Liaison: John F. DunlapPaul T. Ninomura, Chair* Hamid Habibi Richard D. Moeller*Chris P. Rousseau,Co-Vice Chair and Secretary*Richard D. Hermans Tyler NinomuraMichael Patrick Sheerin,Co-Vice Chair*Nolan H
15、osking* Russell N. Olmsted*John M. Dombrowski* Michael R. Keen Heather L. Platt*Douglas S. Erickson* Peter H. Langowski* Gordon P. Sharp*Jonathan J. Flannery* Michael F. Mamayek*James (Skip) Gregory* Farhad Memarzadeh*Denotes members of voting status when the document was approved for publicationASH
16、RAE STANDARDS COMMITTEE 20132014William F. Walter, Chair John F. Dunlap Rick A. LarsonRichard L. Hall, Vice-Chair James W. Earley, Jr. Mark P. ModeraKarim Amrane Steven J. Emmerich Cyrus H. NasseriJoseph R. Anderson Julie M. Ferguson Janice C. PetersonJames Dale Aswegan Krishnan Gowri Heather L. Pla
17、ttCharles S. Barnaby Cecily M. Grzywacz Douglas T. ReindlSteven F. Bruning Rita M. Harrold Julia A. Keen, BOD ExOJohn A. Clark Adam W. Hinge Thomas E. Werkema, Jr., COWaller S. Clements Debra H. KennoyDavid R. Conover Malcolm D. KnightStephanie C. Reiniche, Manager of StandardsASHRAE is a registered
18、 trademark of the American Society of Heating, Refrigerating and Air-Conditioning Engineers, Inc.ANSI is a registered trademark of the American National Standards Institute.Courtesy copy ONLY for staff/committees responsible for this document. ASHRAE (www.ashrae.org). Per international copyright law
19、, additional reproduction, distribution, or transmission in either print or digital form is not permitted without ASHRAEs prior written permission.ANSI/ASHRAE/ASHE Addendum b to ANSI/ASHRAE/ASHE Standard 170-2013 1(This foreword is not part of this standard. It is merelyinformative and does not cont
20、ain requirements necessaryfor conformance to the standard. It has not been pro-cessed according to the ANSI requirements for a standardand may contain material that has not been subject topublic review or a consensus process. Unresolved objec-tors on informative material are not offered the right to
21、appeal at ASHRAE or ANSI.)FOREWORDThis addendum updates the reference requirements of theStandard.Note: In this addendum, changes to the current standardare indicated in the text by underlining (for additions) andstrikethrough (for deletions) unless the instructions specifi-cally mention some other
22、means of indicating the changes.airborne infection isolation (AII): the isolation of patientsinfected with organisms spread by airborne droplet nuclei lessthan 5 m in diameter (see FGI 2010, CDC 2003, andCDC 2005 in Informative Appendix B). For the purposes ofthis standard, the abbreviation “AII” re
23、fers to the room thatprovides isolation.6.1.2.1 Provide heat sources and essential accessories innumber and arrangement sufficient to accommodate the facil-ity needs (reserve capacity), even when any one of the heatsources or essential accessories is not operating due to abreakdown or routine mainte
24、nance. The capacity of theremaining source(s) shall be sufficient to provide for domes-tic hot water, sterilization, and dietary purposes and to pro-vide heating for operating, delivery, birthing, labor, recovery,emergency, intensive care, nursery, and inpatient rooms. (Forfurther information, see F
25、GI 2010 in Informative AppendixB.) Fuel sufficient to support the owners facility operationplan upon loss of fuel service shall be provided on site.6.4 Filter banks shall be provided in accordance with Table6.4. Each filter bank with an efficiency of greater than MERV12 shall be provided with an ins
26、talled manometer or differen-tial pressure measuring device that is readily accessible andprovides a reading of differential static pressure across the fil-ter to indicate when the filter needs to be changed. (For fur-ther information, see FGI 2010 and CDC 2003 inInformative Appendix B.) All of the
27、air provided to a spaceshall be filtered in accordance with Table 6.4, except as other-wise indicated in Section 7.1 for spaces that allow recirculat-ing HVAC room units.Notes for Table 7.1:.b. Pharmacy compounding areas may have additional airchange, differential pressure, and filtering requirement
28、sbeyond the minimum of this table depending on the typeof pharmacy, the regulatory requirements which mayinclude adoption of USP 797), the associated level of riskof the work (see USP 2013 2012 in Informative Appen-dix B), and the equipment utilized in the spaces.i. Minimum total air changes per hou
29、r (ach) shall be thatrequired to provide proper makeup air to kitchen exhaustsystems as specified in ANSI/ASHRAE Standard 154.4Insome cases, excess exfiltration or infiltration to or fromexit corridors compromises the exit corridor restrictions ofNFPA 90A,5the pressure requirements of NFPA 96,6orthe
30、 maximum defined in the table. During operation, areduction to the number of air changes to any extentrequired for odor control shall be permitted when thespace is not in use. (See FGI 2010 in InformativeAppendix B.)7.2.2 Protective Environment (PE) Rooms. Ventilationfor PE rooms shall meet the foll
31、owing requirements:.c. Air distribution patterns within the protective environmentroom shall conform to the following:1. Supply air diffusers shall be above the patient bedunless it can be demonstrated that such a location isnot practical. Diffuser design shall limit air velocity atthe patient bed t
32、o reduce patient discomfort. (SeeASHRAE Standard 55 2010a2013 in InformativeAppendix B.)1Code of Federal Regulations, 21CFR 173.310 (April19992013), U.S. Dept. of Health and Human Services,Food and Drug Administration.2DHHS (NIOSH) Publication No. 94-100 (NIOSH Alert)1994, Controlling Exposures to N
33、itrous Oxide DuringAnesthetic Administration, National Institute for Occupa-tional Safety and Health (CDC), Atlanta, GA.3OSHA 1994. Computerized information system. Washing-ton, DC: U.S. Department of Labor, Occupational Safetyand Health Administration.4ANSI/ASHRAE Standard 154-20032011, Ventilation
34、 forCommercial Cooking Operations, Atlanta: ASHRAE.5NFPA. 20022012. NFPA 90A, Standard for the Installationof Air-Conditioning and Ventilating Systems. NationalFire Protection Association, 1 Batterymarch Park,Quincy, MA 02169.Addendum b to Standard 170-2013Revise Section 3 as follows. The remainder
35、of Section 3 isunchanged.Revise Section 6.1.2.1 as follows.Revise Section 6.4 as follows.Revise the following notes in Table 7.1 as shown. Theremainder of Table 7.1 is unchanged.Revise Section 7.2.2 as shown. The remainder of Section7.2.2 is unchanged.Revise Section 9 as shown. The remainder of Sect
36、ion 9 isunchanged.Courtesy copy ONLY for staff/committees responsible for this document. ASHRAE (www.ashrae.org). Per international copyright law, additional reproduction, distribution, or transmission in either print or digital form is not permitted without ASHRAEs prior written permission.2 ANSI/A
37、SHRAE/ASHE Addendum b to ANSI/ASHRAE/ASHE Standard 170-20136NFPA. 20042014. NFPA 96, Standard for Ventilation Con-trol and Fire Protection of Commercial Cooking Opera-tions. National Fire Protection Association, 1Batterymarch Park, Quincy, MA 02169.7NIOSH Critical Criteria Documents. National Instit
38、ute forOccupational Safety and Health, available at the Centersfor Disease Control and Prevention (CDC) website: http:/www.cdc.gov/niosh/pubs/criteria_date_desc_nopubnumbers.html8NFPA 99-20052012, Standard for Health Care Facilities.National Fire Protection Association, 1 BatterymarchPark, Quincy, M
39、assachusetts USA 02169.ASHRAE. 2010a2013. ANSI/ASHRAE Standard 55, Ther-mal Environmental Conditions for Human Occupancy.Atlanta: ASHRAE.CDC. 2003. Guidelines for Environmental infection control inhealth-care facilities. Morbidity and Mortality WeeklyReport (MMWR) 52(RR10). U.S. Department of Health
40、and Human Services, Centers for Disease Control andPrevention, Atlanta, GA.USP. 20082012. National Formulary, USP-797, Pharmaceuti-cal CompoundingSterile Preparations. U.S. Pharmaco-peial Convention, Rockville, MD.Revise Informative Appendix B as shown. The remainderof Informative Appendix B is unch
41、anged.Courtesy copy ONLY for staff/committees responsible for this document. ASHRAE (www.ashrae.org). Per international copyright law, additional reproduction, distribution, or transmission in either print or digital form is not permitted without ASHRAEs prior written permission.POLICY STATEMENT DEF
42、INING ASHRAES CONCERNFORTHE ENVIRONMENTAL IMPACT OF ITS ACTIVITIESASHRAE is concerned with the impact of its members activities on both the indoor and outdoor environment. ASHRAEsmembers will strive to minimize any possible deleterious effect on the indoor and outdoor environment of the systems andc
43、omponents in their responsibility while maximizing the beneficial effects these systems provide, consistent with acceptedstandards and the practical state of the art.ASHRAEs short-range goal is to ensure that the systems and components within its scope do not impact the indoor andoutdoor environment
44、 to a greater extent than specified by the standards and guidelines as established by itself and otherresponsible bodies.As an ongoing goal, ASHRAE will, through its Standards Committee and extensive technical committee structure,continue to generate up-to-date standards and guidelines where appropr
45、iate and adopt, recommend, and promote those newand revised standards developed by other responsible organizations.Through its Handbook, appropriate chapters will contain up-to-date standards and design considerations as the material issystematically revised.ASHRAE will take the lead with respect to
46、 dissemination of environmental information of its primary interest and will seekout and disseminate information from other responsible organizations that is pertinent, as guides to updating standards andguidelines.The effects of the design and selection of equipment and systems will be considered w
47、ithin the scope of the systemsintended use and expected misuse. The disposal of hazardous materials, if any, will also be considered.ASHRAEs primary concern for environmental impact will be at the site where equipment within ASHRAEs scopeoperates. However, energy source selection and the possible en
48、vironmental impact due to the energy source and energytransportation will be considered where possible. Recommendations concerning energy source selection should be made byits members.Courtesy copy ONLY for staff/committees responsible for this document. ASHRAE (www.ashrae.org). Per international copyright law, additional reproduction, distribution, or transmission in either print or digital form is not permitted without ASHRAEs prior written permission.ASHRAE 1791 Tullie Circle NE Atlanta, GA 30329 www.ashrae.org7/14
