ASTM D5562-1995(2018) Standard Test Method for Determination of the Acidity as Free Fatty Acids Acid Number in the Presence of Ammonium or Triethanolamine Soaps.pdf

上传人:fatcommittee260 文档编号:520115 上传时间:2018-12-03 格式:PDF 页数:2 大小:68.45KB
下载 相关 举报
ASTM D5562-1995(2018) Standard Test Method for Determination of the Acidity as Free Fatty Acids Acid Number in the Presence of Ammonium or Triethanolamine Soaps.pdf_第1页
第1页 / 共2页
ASTM D5562-1995(2018) Standard Test Method for Determination of the Acidity as Free Fatty Acids Acid Number in the Presence of Ammonium or Triethanolamine Soaps.pdf_第2页
第2页 / 共2页
亲,该文档总共2页,全部预览完了,如果喜欢就下载吧!
资源描述

1、Designation: D5562 95 (Reapproved 2018)Standard Test Method forDetermination of the Acidity as Free Fatty Acids/AcidNumber in the Presence of Ammonium or TriethanolamineSoaps1This standard is issued under the fixed designation D5562; the number immediately following the designation indicates the yea

2、r oforiginal adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This test method covers determination of the acidity as

3、free fatty acids in the presence of ammonium or trietha-nolamine soaps, or both, existing in a sample of sulfonated orsulfated oil, or both, by calculation from the total alkalinity andfree-and-alkali combined fatty acids.1.2 The values stated in SI units are to be regarded asstandard.1.3 This stand

4、ard does not purport to address all of thesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appro-priate safety, health, and environmental practices and deter-mine the applicability of regulatory limitations prior to use.1.4 This inte

5、rnational standard was developed in accor-dance with internationally recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards, Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade (TBT)

6、Committee.2. Referenced Documents2.1 ASTM Standards:2D5350 Test Method for Determination of Organically Com-bined Sulfuric Anhydride by Titration, Test Method A3. Significance and Use3.1 This test method is intended for use in the determinationof the acid number of sulfonated and sulfated oils for t

7、hepurpose of quality assurance.4. Apparatus4.1 The apparatus required consists of a glass flask providedwith a glass stopper and an air condenser. The connectionbetween the flask and the condenser shall be a ground joint.Perforated glass beads shall be used to prevent bumping.4.1.1 FlaskAn Erlenmeye

8、r flask (Fig. 1) made of a boro-silicate glass, having a capacity of approximately 300 mL andprovided with a glass stopper.4.1.2 Condenser, consisting of a glass tube, 915 mm (36 in.)in length and 8 mm (516 in.) in outside diameter. The lower endof the tube shall be flared and ground to fit the mout

9、h of theErlenmeyer flask.4.1.3 Glass BeadsPerforated glass beads, made of chemi-cally resistant glass, approximately 4 mm (532 in.) in diameter.Before using, the glass beads shall be boiled thoroughly inseveral portions of water or until the wash water reacts neutralto a methyl orange indicator.5. R

10、eagents5.1 Ethyl Ether.5.2 Methyl Orange Indicator Solution (1 g/L)Dissolve 0.1g of methyl orange in 100 mL of water.5.3 Sodium Chloride (NaCl), solid.5.4 Sodium Hydroxide, Standard Solution (1 N)Accurately prepare and standardize a 1 N sodium hydroxide(NaOH) solution. Express the strength or concen

11、tration of thesolution as mg of KOH per mL; 1 mL of 1 N NaOH solutionis equivalent to 56.1 mg of KOH.5.5 Sodium Hydroxide, Standard Solution (0.5 N)Accurately prepare and standardize a 0.5 N NaOH solution.Express the strength of the solution as mg of KOH per mL; 1mL of 0.5 N NaOH solution is equival

12、ent to 28.05 mg of KOH.5.6 Sulfuric Acid, Standard (0.5 N)Accurately prepare andstandardize a 0.5 N sulfuric acid (H2SO4) solution. Express thestrength of the solution as mg of KOH per mL; 1 mL of 0.5 NH2SO4is equivalent to 28.05 mg of KOH.5.7 Sulfuric Acid (1 + 19)Carefully mix 1 volume ofconcentra

13、ted sulfuric acid (H2SO4, sp gr 1.84) into 19 volumesof water while stirring.1This test method is under the jurisdiction of ASTM Committee D31 on Leatherand is the direct responsibility of Subcommittee D31.08 on Fats and Oils. This testmethod was developed in cooperation with the American Leather Ch

14、emists Assn.(Method H 52-1956).Current edition approved Sept. 1, 2018. Published October 2018. Originallyapproved in 1994. Last previous edition approved in 2011 as D5562 95(2011).DOI: 10.1520/D5562-95R18.2For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer S

15、ervice at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United StatesThis international standard was developed i

16、n accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.16. Procedure6.1 The proce

17、dure consists of two determinations: (1) totalalkalinity and (2) free-and-alkali-combined fatty acids.6.1.1 Total AlkalinityDetermine the total alkalinity asdescribed in the determination of organically combined sulfu-ric anhydride (see Test Method D5350).6.1.2 Free and Alkali-Combined Fatty AcidsEx

18、tract thetotal sulfated and sulfonated fatty matter as described in thedetermination of total active ingredients (see Test MethodD5350), but omit the dehydration of the extract (see Note 1).Add exactly 0.5 mL of 0.5 N NaOH solution to the extract,evaporate the ether to a volume of approximately 25 m

19、L, addapproximately 50 mL of neutral alcohol, and titrate the mixturewith 0.5 N NaOH solution to a phenolphthalein end point.NOTE 1In the presence of acetates, wash the ether layer carefully withconcentrated NaCl solution until one or two drops of 0.5 N NaOH solutionadded to the final wash water are

20、 neutral to phenolphthalein indicator.7. Calculation7.1 Calculate the free and alkali-combined fatty acids asdescribed in the determination of acidity as free fatty acids,(see Test Methods D5350). Calculate the acidity as free fattyacids in the presence of ammonium or triethanolamine soaps,or both,

21、as follows:K 5 J 2 A (1)or% free fatty acids 5 0.503 K (2)where:K = acid number, mg of KOH/g,J = free and alkali-combined fatty acids, andA = total alkalinity.8. Precision and Bias8.1 This test method is adopted from the procedures of theAmerican Leather Chemists Association, where it has longbeen i

22、n use and was approved for publication before theinclusion of precision and bias statements was mandated. Theoriginal interlaboratory test data are no longer available. Theuser is cautioned to verify by the use of reference materials, ifavailable, that the precision and bias (or reproducibility) of

23、thistest method is adequate for the contemplated use.9. Keywords9.1 acidity; free fatty acids; leather; sulfonated and sulfatedoilsASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard

24、are expressly advised that determination of the validity of any such patent rights, and the riskof infringement of such rights, are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif no

25、t revised, either reapproved or withdrawn. Your comments are invited either for revision of this standard or for additional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which

26、you may attend. If you feel that your comments have not received a fair hearing you shouldmake your views known to the ASTM Committee on Standards, at the address shown below.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,Unit

27、ed States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the Copyright Clearance Center, 222Rosewood Drive, Danvers, MA 01923, Tel: (978) 646-2600; http:/ 1 Apparatus for Determination of Organically CombinedSulfuric Anhydride, Method AD5562 95 (2018)2

展开阅读全文
相关资源
猜你喜欢
相关搜索

当前位置:首页 > 标准规范 > 国际标准 > ASTM

copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1