1、Designation: D7510 10Standard Practice forPerforming Detection and Quantitation Estimation and DataAssessment Utilizing DQCALC Software, based on ASTMPractices D6091 and D6512 of Committee D19 on Water1, 2This standard is issued under the fixed designation D7510; the number immediately following the
2、 designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This software was develop
3、ed to automate calculationswithin three ASTM standards: Practices D2777 (outlier re-moval section), D6091, and D6512.1.2 The program calculates detection estimates (DE) andquantitation estimates (QE) for the constant, straight-line,exponential, and hybrid (Rocke-Lorenzato) models of thevariation of
4、inter or intra laboratory standard deviation(ILSD) with concentration. Calculations are shown in theDE_QE worksheet and results are shown in the DLs DQCALC; IDE; IQE; quantitationASTM International takes no position respecting the validity of any patent rights asserted in connection with any item me
5、ntionedin this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the riskof infringement of such rights, are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committe
6、e and must be reviewed every five years andif not revised, either reapproved or withdrawn. Your comments are invited either for revision of this standard or for additional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeti
7、ng of theresponsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you shouldmake your views known to the ASTM Committee on Standards, at the address shown below.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO
8、 Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the ASTM website (www.astm.org/COPYRIGHT/).D7510 102
