1、REVISIONS LTR DESCRIPTION DATE APPROVED A Add silver plated designs, and source 98291. Editorial changes throughout. 20 Sep 1988 R. Marbais B Add source 24931. 25 Feb 1991 C. W. Koeller C Add vendor PINs. Address change for 95077. 10 Nov 1994 Randy Larson D Frequency range changes. 22 May 1995 Randy
2、 Larson E PIN and source update 16 Nov 2001 Robert M. Heber Prepared in accordance with MIL-STD-100 REV PAGE REV E E E E E REV STATUS OF PAGES PAGE 1 2 3 4 5 PREPARED BY PMIC N/A Ron Gary DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OHIO 43216-5000 CHECKED BY TITLE Don Seger APPROVED BY R. Marbais CONN
3、ECTOR, RECEPTACLE, ELECTRICAL, COAXIAL, RADIO FREQUENCY, SERIES SMC, PRINTED CIRCUIT BOARD MOUNT, RIGHT ANGLE SIZE CAGE CODE 037Z3 DWG. NO. 85140 Original date of drawing 17 December 1985 A REV E PAGE 1 OF 5 AMSC N/A 5935-E625 DISTRIBUTION STATEMENT A. Approved for public release; distribution is un
4、limited.Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 85140 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 A REV E PAGE 2 ENGINEERING DATA: Nominal impedance: 50 ohms. Frequency range: 0 to 10 GHz. Voltage rati
5、ng: 335 volts rms, maximum, at sea level, 85 volts rms, maximum at 70,000 feet. Temperature rating: -65C to +165C. REQUIREMENTS: Requirements of drawing 84148 are applicable. Dimensions and configuration: See figure 1. Force to engage and disengage: Longitudinal force: 14 pounds maximum engage, 2 po
6、unds minimum disengage. Torque: Not applicable. Coupling proof torque: Not applicable. Inspection conditions: Not applicable. Hermetic seal: Not applicable. Leakage (pressurized connectors): Not applicable. Insulation resistance: Method 302, test condition B, MIL-STD-202. 1,000 megohms, minimum. Cen
7、ter contact retention: Minimum axial force: 6.0 pounds from mating end; 4.0 pounds from opposite end. Torque: 3 inch-ounce. Solderability 1/: Method 208 of MIL-STD-202. Salt spray (corrosion): Method 101, test condition B, MIL-STD-202. Voltage standing wave ratio (VSWR): Not applicable. Swept freque
8、ncy VSWR test setup: Not applicable. Connector durability: Insertion and withdrawal force: 500 cycles, minimum at 12 cycles/minute, maximum. The mating force shall meet the mating characteristics requirements. Initial: 14 pounds, minimum. Finial: 2 pounds, minimum disengagement. 14 pounds, maximum e
9、ngage and disengage. Contact resistance (milliohms, maximum): Initial After environment Center contact: 6.0 8.0 Outer contact: 1.0 1.5 Braid to body Not applicable Not applicable _ 1/ For quality conformance inspection, the test shall be performed in group B following VSWR. Provided by IHSNot for Re
10、saleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 85140 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 A REV E PAGE 3 PIN Dimension A 85140DBG-1 .155 (3.94) .010 (0.25) 85140DBG-2 .125 (3.18) .010 (0.25) 85140DBG-3 .093 (2.36) .010 (0.25)
11、85140DBS-1 .155 (3.94) .010 (0.25) 85140DBS-2 .125 (3.18) .010 (0.25) 85140DBS-3 .093 (2.36) .010 (0.25) NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for information only. 3. All undimensioned pictorial representations are for reference purposes only. 4. Configuration optional
12、 Dimension specified is maximum envelope diameter of feature. FIGURE 1. General configuration. .Inches mm Inches mm .001 0.02 .067 1.70 .002 0.05 .100 2.54 .003 0.08 .200 5.08 .008 0.20 .218 5.54 .020 0.51 .375 9.52 .038 0.97 .385 9.78 .047 1.19 .435 11.05 .060 1.52 .600 15.24 Provided by IHSNot fo
13、r ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 85140 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 A REV E PAGE 4 Dielectric withstanding voltage: Method 301 of MIL-STD-202. 1,000 volts rms, at sea level. Vibration, high frequency.
14、 MIL-STD-202, method 204, test condition D. Shock (specified pulse): MIL-STD-202 method 213, test condition H. Thermal shock: MIL-STD-202, method 107, test condition B. Moisture resistance: Not applicable. Corona level: Not applicable. RF high potential withstanding voltage: Voltage and frequency: 6
15、00 volts rms at 5 MHz. Leakage current: Not applicable. Cable retention force: Not applicable. Coupling mechanism retention force: Not applicable. RF leakage: Not applicable. Insertion loss: Not applicable. Part or Identifying Number (PIN): 85140DBG-1, 85140DBG-2, 85140DBG-3, 85140DBS-1, 85140DBS-2,
16、 and 85140DBS-3 (see table I). TABLE I. Cross-reference of PINs. Preferred PIN 1/ Superseded PIN 1/ 85140DBG-1 85140DBG-2 85140DBG-3 85140DBGN-1 85140DBGN-2 85140DBGN-3 1/ Superseded parts may be used until stock is exhausted. New PIN marking is effective as of the date of this revision. Note: These
17、 parts are for use in general radio frequency applications. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SIZE CAGE CODE DWG NO. 037Z3 85140 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 A REV E PAGE 5 Approved sources of supply are liste
18、d herein. Additional sources will be added as they become available. The vendors listed on the requirements drawing have agreed to this drawing and a certificate of compliance has been submitted to DSCC-VAI. DSCC drawing PIN 1/ Vendor CAGE number Vendor reference PIN 85140DBG-1 00795 24931 95077 257
19、0000G00E-000 37JR110-1 2285-0007 85140DBG-2 00795 24931 95077 2570000G00E-001 37JR110-6 2285-0004 85140DBG-3 00795 24931 95077 2570000G00E-002 37JR110-7 2285-0005 85140DBS-1 00795 95077 2570000A00E-000 2285-0008 85140DBS-2 00795 95077 2570000A00E-001 2285-0009 85140DBS-3 00795 95077 2570000A00E-002
20、2285-0010 1/ Parts must be purchased to this DSCC PIN to assure that all performance requirements and tests are met. Vendor CAGE Vendor name number and address 00795 Delta Electronics 416 Cabot Street Beverly, MA 01915 24931 Specialty Connector Co. 2100 Earlywood Dr. Franklin, IN 46131 95077 Soliton/Vector Microwave Products 3301 Electronics Way West Palm Beach, FL 33407 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
