1、AMSC N/A FSC 5920 INCH-POUND MIL-PRF-15160/30B 12 October 2011 SUPERSEDING MIL-PRF-15160/30A 14 March 2005 PERFORMANCE SPECIFICATION SHEET FUSES, STYLE F30 This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product
2、described herein shall consist of this specification sheet and MIL-PRF-15160. Ltr Inches mm Min Max Min Max A 9.938 10.062 252.43 255.57 B .804 .820 20.42 20.83 C .500 - 12.70 - D - .781 - 19.84 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. FIGURE 1. Styl
3、e F30, characteristic A. INACTIVE FOR NEW DESIGN AFTER 27 DECEMBER 1990 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-15160/30B 2 REQUIREMENTS: Interface and physical dimensions: See figure 1. Body: Fiber. Ferrule: Brass. Finish: Nickel or
4、bright alloy or bright dipped, silver plated when specified. Terminal strength: 5 inch-pounds. Type designation: Type designation shall be as specified in table 1. Electrical: Voltage rating: 10,000 volts maximum. Overload interrupt: Maximum 1 hour at 135 percent of rated current. Short circuit inte
5、rrupt: 5 amperes at 10,000 volts ac. Current capacity: Maximum 1.5 hours at 110 percent of rated current. Current rating: See table 1. Voltage rating: See table 1. Characteristic: See table 1. TABLE 1. Type designation and electrical rating. 1/ Style Characteristic Voltage Current F30 A 10,000 .06 A
6、 F30 A 10,000 .12 A F30 A 10,000 .25 A F30 A 10,000 .38 A F30 A 10,000 .50 A F30 A 10,000 .75 A F30 A 10,000 1 A F30 A 10,000 1.5 A F30 A 10,000 2 A F30 A 10,000 3 A 1/ For silver plated terminals, the designator “S” is added after the current rating. VERIFICATION: Qualification is not applicable fo
7、r this specification sheet and is replaced by successful completion of group A and group B inspections in MIL-PRF-15160, before product is delivered. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-15160/30B 3 The margins of this specificatio
8、n are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this doc
9、ument based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodians: Preparing activity: Army - CR DLA - CC Navy - SH Air Force - 85 (Project 5920-2011-033) DLA - CC Review activities: Army - MI Air Force - 99 NOTE: The activities listed a
10、bove were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
