DLA MS28050 REV B-2005 VALVE CHECK LOW PRESSURE INTERNAL THREADS《低气压内螺纹检查阀门》.pdf

上传人:arrownail386 文档编号:696923 上传时间:2019-01-02 格式:PDF 页数:3 大小:38.70KB
下载 相关 举报
DLA MS28050 REV B-2005 VALVE CHECK LOW PRESSURE INTERNAL THREADS《低气压内螺纹检查阀门》.pdf_第1页
第1页 / 共3页
DLA MS28050 REV B-2005 VALVE CHECK LOW PRESSURE INTERNAL THREADS《低气压内螺纹检查阀门》.pdf_第2页
第2页 / 共3页
DLA MS28050 REV B-2005 VALVE CHECK LOW PRESSURE INTERNAL THREADS《低气压内螺纹检查阀门》.pdf_第3页
第3页 / 共3页
亲,该文档总共3页,全部预览完了,如果喜欢就下载吧!
资源描述

1、 AMSC N/A FSC 4820 MS28050B INCH-POUND 14 September 2005 SUPERSEDING MS28050A 21 May 2004 DETAIL SPECIFICATION SHEET VALVE, CHECK, LOW PRESSURE, INTERNAL THREADS This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the pr

2、oduct described herein shall consist of this specification sheet and MIL-V-6129. FIGURE 1. Valve, check, low pressure, internal threads. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS28050B 2 Part or Identifying Number (PIN) A max (mm) B max (mm)

3、 C .0625 (1.16mm)D min (mm) Weight max (lb)(mm) Boss AND10050 Gasket two each required SAE-AS28778 Tubing size (ref) OD (mm) MS28050-1 1.750 (44.45) 1.125 (28.58) 2.250 (57.15) 0.250 (6.35) 0.300 (7.62) -4 -4 0.250 (6.35) MS28050-2 2.000 (50.80) 1.125 (28.58) 2.500 (63.50) 0.250 (6.35) 0.300 (7.62)

4、6 -6 0.375 (9.53) MS28050-3 2.000 (50.80) 1.250 (31.75) 2.500 (63.50) 0.281 (7.14) 0.300 (7.62) -8 -8 0.500 (12.70) MS28050-4 2.188 (55.58) 1.375 (34.93) 3.000 (76.20) 0.312 (7.92) 0.450 (11.43) -10 -10 0.625 (15.88) MS28050-5 2.500 (63.50) 1.750 (44.45) 3.500 (88.90) 0.344 (8.74) 0.600 (15.24) -16

5、 -16 1.000 (25.40) NOTES: 1. Dimensions are in inches, unless otherwise specified. 2. Metric equivalents are given for information only. 3. Tolerances: .016 inch (0.41 mm). FIGURE 1. Valve, check, low pressure, internal threads - Continued. REQUIREMENTS: Dimensions and configurations: See figure 1.

6、Designed for use with air, coolants and water at pressures not exceeding 50 PSI (3.45 bar). Material in accordance with MIL-V-6129. Threads in accordance with MIL-V-6129. Marginal notations. Marginal notations are not used in this revision to identify changes due to the extent of the changes. Refere

7、nce documents. In addition to MIL-V-6129, this document references the following: AND10050 SAE-AS28778 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS28050B CONCLUDING MATERIAL Custodians: Preparing activity: Navy - AS DLA - CC Air Force - 99 DLA

8、 CC Review activities: (Project 4820-2005-001) Navy - MC, SA Air Force - 70, 71 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-

展开阅读全文
相关资源
猜你喜欢
  • DIN EN 13573-2009 Inland navigation vessels - Anchoring coupling towing hauling and mooring systems English version of DIN EN 13573 2009-04《内河运输船舶 抛锚、连接、拖曳、牵引和停泊系统》.pdf DIN EN 13573-2009 Inland navigation vessels - Anchoring coupling towing hauling and mooring systems English version of DIN EN 13573 2009-04《内河运输船舶 抛锚、连接、拖曳、牵引和停泊系统》.pdf
  • DIN EN 13574-2001 Inland navigation vessels - Permanently installed climbing devices with a length not exceeding 5 m German version EN 13574 2001《内河运输船只 长度不超过5米的永久性攀缘装置》.pdf DIN EN 13574-2001 Inland navigation vessels - Permanently installed climbing devices with a length not exceeding 5 m German version EN 13574 2001《内河运输船只 长度不超过5米的永久性攀缘装置》.pdf
  • DIN EN 13575-2012 Static thermoplastic tanks for the above ground storage of chemicals - Blow moulded or rotationally moulded polyethylene tanks - Requirements and test methods Ger.pdf DIN EN 13575-2012 Static thermoplastic tanks for the above ground storage of chemicals - Blow moulded or rotationally moulded polyethylene tanks - Requirements and test methods Ger.pdf
  • DIN EN 13577-2007 Chemical attack on concrete - Determination of aggressive carbon dioxide content in water German version EN 13577 2007《混凝土的化学反应腐蚀 水中生效二氧化碳含量的测定》.pdf DIN EN 13577-2007 Chemical attack on concrete - Determination of aggressive carbon dioxide content in water German version EN 13577 2007《混凝土的化学反应腐蚀 水中生效二氧化碳含量的测定》.pdf
  • DIN EN 13578-2004 Products and systems for the protection and repair of concrete structure - Test method - Compatibility on wet concrete German version EN 13578 2003《混凝土结构的保护和维修用产品.pdf DIN EN 13578-2004 Products and systems for the protection and repair of concrete structure - Test method - Compatibility on wet concrete German version EN 13578 2003《混凝土结构的保护和维修用产品.pdf
  • DIN EN 13579-2002 Products and systems for the protection and repair of concrete structures - Test methods - Drying test for hydrophobic impregnation German version EN 13579 2002《混.pdf DIN EN 13579-2002 Products and systems for the protection and repair of concrete structures - Test methods - Drying test for hydrophobic impregnation German version EN 13579 2002《混.pdf
  • DIN EN 13580-2002 Products and systems for the protection and repair of concrete structures - Test methods - Water absorption and resistance to alkali for hydrophobic impregnations.pdf DIN EN 13580-2002 Products and systems for the protection and repair of concrete structures - Test methods - Water absorption and resistance to alkali for hydrophobic impregnations.pdf
  • DIN EN 13581-2002 Products and systems for the protection and repair of concrete structures - Test method - Determination of loss of mass of hydrophobic impregnated concrete after .pdf DIN EN 13581-2002 Products and systems for the protection and repair of concrete structures - Test method - Determination of loss of mass of hydrophobic impregnated concrete after .pdf
  • DIN EN 13583-2012 Flexible sheets for waterproofing - Bitumen plastic and rubber sheets for roof waterproofing - Determination of hail resistance German version EN 13583 2012《防水软板 .pdf DIN EN 13583-2012 Flexible sheets for waterproofing - Bitumen plastic and rubber sheets for roof waterproofing - Determination of hail resistance German version EN 13583 2012《防水软板 .pdf
  • 相关搜索

    当前位置:首页 > 标准规范 > 国际标准 > 其他

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1