ETSI I-ETS 300 314 PRA1-1996 AMD prA1 Integrated Services Digital Network (ISDN) Digital Subscriber Signalling System No One (DSS1) Protocol Implementation Conformance Statement (Ptw.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

DIN 799-1-1981 Foundation blocks《基础砌块》.pdf

DIN 7990-2008 Hexagon head bolts with hexagon nut for steel structures《钢结构用带六角螺母的六角头螺栓》.pdf

DIN 7992-2010 T-head bolts with large head《T形大头螺栓》.pdf

DIN 7995-2016 Cross recessed raised countersunk head wood screws《十字槽凸起沉头木螺钉》.pdf

DIN 7996-2016 Cross recessed round head wood screws《十字槽圆头木螺钉》.pdf

DIN 7997-2016 Cross recessed countersunk head wood screws《十字槽沉头木螺钉》.pdf

DIN 7998-1975 Threads and Thread Ends for Wood Screws《木螺钉用螺纹和螺纹端》.pdf

DIN 8000-1962 Design Dimensions and Errors of Hobs for Involute Spur Gears Fundamental Terms《渐开线正齿轮加工用滚铣刀的设计尺寸与误差 基本术语》.pdf

DIN 8002-1955 Metal-cutting Tools Hobs for Spur Gears with Clutch Drive Slot or Keyway Modules 1 to 20《金属切削刀具 带离合器驱动槽或键槽模数为1至20 的正齿轮加工用的滚铣刀 》.pdf