1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 11 26 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE2003 03 19 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.18, 3.19, 4 deleted 1996 11 15 Activated N. J. KomatsuPrinted copies are un
2、controlled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, WAVES, JACQUARD WOVEN WSS-M1H713-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for
3、material used as an interior trim fabric for the 1998 MY BE146. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must
4、conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5 % tolerance (ASTM D 3775) Warp 242 ends/10 cm Weft 180 picks/10 cm 3.4.2 Fabric Weight, range 305 - 335 g/m2(FLTM BN 106-01) 3.5 COMPOSITION (ASTM D 629) Fabric
5、100 % polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H713-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 760 dtex resultant f196 (polyester, semi-dull, air texturised, round section) Weft 760 dtex resultant f128 (polyester, bright, air textu
6、rised, trilobal section) 3.7 METHOD OF DYEING Yarn dyed and spun or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded compos
7、ite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.
