1、 ENGINEERING STANDARDS Test Procedure LIMITED USE EDS-T-2108 Measurement of the Thickness of Clutch Linings Do Not Use on New Program; No Replacement. A) ? (8$ % ?U9I Note: 8 E:48t G8 =97 FF7 957%L+ , FG P-P Program 72P# 957%L: 6#$ . Copyright 2011 General Motors Company All Rights Reserved December
2、 2011 Originating Department: GM Korea Engineering Standards Page 1 of 3 Version : 4 1 Scope Note: Nothing in this standard supersedes applicable laws and regulations. Note: In the event of conflict between the Korean and English language, the Korean language shall take precedence. 1.1 Purpose and A
3、pplicability. This specification determines the clutch lining wear on the pressure plate and fly wheel side. 2 References Note: Only the latest approved standards are applicable unless otherwise specified. 2.1 External Standards/Specifications. None 2.2 GM Standards/Specifications. None 2.3 Addition
4、al References. None 3 Resources 3.1 Equipment. 3.1.1 Measuring Setup (see Figure 1). 4 Procedures 4.1 Preparation. If the linings are supplied as clutch disk assemblies remove them from the disks prior to measurement. 4.2 Conditions. 4.2.1 Test Conditions. Deviations from the requirements of this st
5、andard shall have been agreed upon. Such requirements shall be specified on component drawings, test certificates, reports, etc. 4.3 Instructions. 4.3.1 The lining to be measured is compressed between 2 even plates with (2,00050) N. 1 P7 :0 : ., E:48 6&F !7$ :4-8! 9I8x $4=F 3L 6$ . :0 : F67t 7568 18
6、 88x 7 , F6* 72T8p) F$ . 1.1 +95 -C 957 -88 . A) ? (8$8 *+(8x ?U9IFd 88F . 2 4) E:4 / :0 : C-H +d%P 9I8 6# F 48 07 38%P E:48x 957F$ . 2.1 17 E:4 / . None 2.2 GM E:4 / . EDS-T-2113 2.3 dA E:4 / . None 3 4G 88 3.1 4G 8/x . 3.1.1 ?U9I 2X/x (,* 1 =l9 ). 4 4G 9) 9P9I / -PF%L6$ . Issue / P9I8)Y Publicatio
7、n Date / 38 88 Description (Organization) / 9PP9I76 (:04.2P ) 4 DEC 2011 Apply new Engineering Standard Template. Limited use with no replacement (TM Test & Validation PMT Team) / 4 d3TE:4 64 957 . F9I957 ($4=E:4 68 ) =* (-2dP-P4G :D4 ) GM KOREA ENGINEERING STANDARDS EDS-T-2108 Copyright 2011 General Motors Company All Rights Reserved December 2011 Page 3 of 3 Version : 4 Figure 1: Setup for Measuring the Thickness of Clutch Linings / ,* 1: A) ? (8$8 % * ?U9IFd 88F 8?
