ITU-R S 580-6-2003 Radiation diagrams for use as design objectives for antennas of earth stations operating with geostationary satellites (Question itu-r 42 4)《用作运行于静止卫星地球站天线的设计目标的.pdf

上传人:syndromehi216 文档编号:793645 上传时间:2019-02-02 格式:PDF 页数:3 大小:98.98KB
下载 相关 举报
ITU-R S 580-6-2003 Radiation diagrams for use as design objectives for antennas of earth stations operating with geostationary satellites (Question itu-r 42 4)《用作运行于静止卫星地球站天线的设计目标的.pdf_第1页
第1页 / 共3页
ITU-R S 580-6-2003 Radiation diagrams for use as design objectives for antennas of earth stations operating with geostationary satellites (Question itu-r 42 4)《用作运行于静止卫星地球站天线的设计目标的.pdf_第2页
第2页 / 共3页
ITU-R S 580-6-2003 Radiation diagrams for use as design objectives for antennas of earth stations operating with geostationary satellites (Question itu-r 42 4)《用作运行于静止卫星地球站天线的设计目标的.pdf_第3页
第3页 / 共3页
亲,该文档总共3页,全部预览完了,如果喜欢就下载吧!
资源描述

1、 Rec. ITU-R S.580-6 1 RECOMMENDATION ITU-R S.580-6Radiation diagrams for use as design objectives for antennas of earth stations operating with geostationary satellites (Question ITU-R 42/4)(1982-1986-1990-1992-1993-1994-2003) The ITU Radiocommunication Assembly, considering a) that efficient utiliz

2、ation of the radio spectrum is a primary factor in the management of the geostationary-satellite orbit (GSO); b) that the side-lobe characteristic of earth-station antennas is one of the main factors in determining the minimum spacing between satellites and therefore the extent to which the radio sp

3、ectrum can be efficiently employed; c) that the radiation diagram of antennas directly affects both the e.i.r.p. outside the main radiation axis and the power received by the side lobes; d) that the construction of antennas with improved side-lobe characteristics may be envisaged using current desig

4、n techniques but that their practical applications may involve increase in cost; e) that the Radiocommunication Study Groups are studying the potential advantages of using antennas with improved side-lobe characteristics for a better utilization of the GSO, recommends 1 that new antennas of an earth

5、 station operating with a geostationary satellite should have a design objective such that the gain, G, of at least 90% of the side-lobe peaks does not exceed: dBilog2529 =G (G being the gain relative to an isotropic antenna and being the off-axis angle in the direction of the GSO referred to the ma

6、in-lobe axis). This requirement should be met for between 1 or (100 /D) whichever is the greater and 20 for any off-axis direction which is within 3 of the GSO; 2 for an off-axis angle, , greater than the limits specified above, Recommendation ITU-R S.465 should be used as a reference (see Note 5);

7、2 Rec. ITU-R S.580-6 0580-01S20203 +3GSO(equatorial plane)Antennamain-lobe axisEarthstationSatellitelongitudeAffectedzoneFIGURE 1Example of a zone around the GSO to which the design objectivefor earth-station antennas applies1 (or 100 /D )FIGURE 1/S.580.D01 = 16 CM 3 that the following Notes should

8、be considered part of this Recommendation. NOTE 1 This Recommendation primarily addresses the GSO sharing criteria. However, it must be emphasized that the application of this Recommendation should not prejudice the antenna characteristics concerned with frequency coordination between the FSS and te

9、rrestrial services (see Recommendation ITU-R S.465). NOTE 2 When asymmetric beam or asymmetric aperture antennas are used, the side-lobe radiation in the direction of the GSO can be reduced if the minor axis of the beam (major axis of the antenna aperture) is oriented so that it is parallel to the G

10、SO arc. In this case, the alignment of the antenna aperture axes relative to the GSO arc would facilitate the compliance with recommends 1 in the affected zone around the GSO arc as indicated in Fig. 1: for the aperture minor axis plane, Recommendation ITU-R S.465 should be complied with for any off

11、axis angle beyond 1 or (100 /De), whichever is the greater but not exceeding 3, where Deis provisionally defined as the circular equivalent diameter using the aperture area of the asymmetric aperture antenna as given below:= /4ADeRec. ITU-R S.580-6 3 where A is the aperture area of the asymmetrical

12、 antenna; for the aperture major axis plane, recommends 1 should be complied with for any off-axis angle beyond 1 or (100 /De), whichever is the greater but not exceeding 2, where Deis provisionally defined above. NOTE 3 This Recommendation applies to antennas with D/ greater than or equal to 50. Fu

13、rther studies are required to determine a design objective for circular aperture antennas having a D/ less than 50, and also to confirm the definition of Defor the asymmetric aperture antennas. NOTE 4 The method of statistical processing of side-lobe peaks is dealt with in Recommendation ITU-R S.732

14、 NOTE 5 In those cases where there is discontinuity between this design objective Recommendation and the reference radiation patterns of Recommendation ITU-R S.465, the gain, G, of at least 90% of the side-lobe peak is defined as follows: = 3.2620fordBi5.3G NOTE 6 For the analysis of an antenna pat

15、tern for angles not specified in this Recommendation, additional mathematical expressions from Appendix 7 of the Radio Regulations may be used as a reference to represent the radiation pattern limits for less than 1 or (100 /D), whichever is the greater. Further study is required to define the most

16、adequate expressions for this purpose. NOTE 7 Small earth-station antennas with improved main beam and side-lobe characteristics are being developed. It is indicated that the efficient use of the GSO may necessitate reflecting these improved characteristics in the ITU Radiocommunication Assembly tex

17、ts and Recommendations. NOTE 8 The performance objectives in 1 have been met by off-set-fed type antennas operating in the 10-14 GHz with D/ 35 and by off-set-fed type receive only antennas operating in the 10.7-11.7 GHz band with D/ 22. NOTE 9 Theoretical calculations supported by preliminary test

18、results of the side-lobe radiation pattern, in the diagonal plane, for square microstrip array antennas with D/ 26 meet the current design objective of 1. These tests were performed on an active array in the 14 GHz band. Further studies are required to confirm that this design objective can be applied to square microstrip phased array antennas.

展开阅读全文
相关资源
猜你喜欢
  • ANSI ISO IEC 10206-1991 Information technology - Programming languages - Extended Pascal (Adopted by INCITS)《信息技术.程序设计语言.INCITS采纳的扩展Pascal语言》.pdf ANSI ISO IEC 10206-1991 Information technology - Programming languages - Extended Pascal (Adopted by INCITS)《信息技术.程序设计语言.INCITS采纳的扩展Pascal语言》.pdf
  • ANSI ISO IEC 10279-1991 Information technology - Programming languages - Full BASIC《信息技术.程序设计语言.INCITS采纳的全BASIC语言》.pdf ANSI ISO IEC 10279-1991 Information technology - Programming languages - Full BASIC《信息技术.程序设计语言.INCITS采纳的全BASIC语言》.pdf
  • ANSI ISO IEC 10373-3-2001 Identification cards - Test methods - Part 3 Integrated circuit(s) cards with contacts and related interface devices (Adopted by INCITS)《识别卡.试验方法.第3部分 INC.pdf ANSI ISO IEC 10373-3-2001 Identification cards - Test methods - Part 3 Integrated circuit(s) cards with contacts and related interface devices (Adopted by INCITS)《识别卡.试验方法.第3部分 INC.pdf
  • ANSI ISO IEC 10373-7-2001 Identification cards - Test methods - Part 7 Vicinity cards (Adopted by INCITS)《识别卡.试验方法.第7部分 INCITS采用邻近卡》.pdf ANSI ISO IEC 10373-7-2001 Identification cards - Test methods - Part 7 Vicinity cards (Adopted by INCITS)《识别卡.试验方法.第7部分 INCITS采用邻近卡》.pdf
  • ANSI ISO IEC 10536-2-1995 Identification cards - Contactless integrated circuit(s) cards - Part 2 Dimensions and location of coupling areas (Adopted by INCITS)《识别卡.无接触点集成电路卡.第2部分 I.pdf ANSI ISO IEC 10536-2-1995 Identification cards - Contactless integrated circuit(s) cards - Part 2 Dimensions and location of coupling areas (Adopted by INCITS)《识别卡.无接触点集成电路卡.第2部分 I.pdf
  • ANSI ISO IEC 10641-1993 Computer Graphics and Image Processing - Conformance Testing of Implementations of Graphics Standards (Adopted by INCITS)《信息技术.计算机图形和图像处理.INCITS采纳的图形标准实现的一致.pdf ANSI ISO IEC 10641-1993 Computer Graphics and Image Processing - Conformance Testing of Implementations of Graphics Standards (Adopted by INCITS)《信息技术.计算机图形和图像处理.INCITS采纳的图形标准实现的一致.pdf
  • ANSI ISO IEC 10741-1-1995 Information technology - User system interfaces - Dialogue interaction - Part 1 Cursor control for text editing (Adopted by INCITS)《信息技术.用户系统界面.对话交互作用.第1部.pdf ANSI ISO IEC 10741-1-1995 Information technology - User system interfaces - Dialogue interaction - Part 1 Cursor control for text editing (Adopted by INCITS)《信息技术.用户系统界面.对话交互作用.第1部.pdf
  • ANSI ISO IEC 10746-2-1996 Information technology - Open Distributed Processing - Reference Model Foundations (Adopted by INCITS)《信息技术.开放式分布加工.参考模型 被INCITS采用的基础》.pdf ANSI ISO IEC 10746-2-1996 Information technology - Open Distributed Processing - Reference Model Foundations (Adopted by INCITS)《信息技术.开放式分布加工.参考模型 被INCITS采用的基础》.pdf
  • ANSI ISO IEC 10746-3-1996 Information technology - Open Distributed Processing - Reference Model Architecture (Adopted by INCITS)《信息技术.开放式分布加工.参考模型 被INCITS采用的架构》.pdf ANSI ISO IEC 10746-3-1996 Information technology - Open Distributed Processing - Reference Model Architecture (Adopted by INCITS)《信息技术.开放式分布加工.参考模型 被INCITS采用的架构》.pdf
  • 相关搜索

    当前位置:首页 > 标准规范 > 国际标准 > 其他

    copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
    备案/许可证编号:苏ICP备17064731号-1