JUS B H8 090-1996 Petroleum and petroleum products - Determination oj vanadium content in special fuel oils - Spectrophotometric method《石油和石油产品 特殊燃油中钒含量的测定 分光光度法》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

AGMA 10FTM15-2010 Drive Line Analysis for Tooth Contact Optimization of High Power Spiral Bevel Gears《驱动高功率螺旋锥齿轮齿接触的优化线性分析》.pdf

AGMA 10FTM16-2010 Analysis of Load Distribution in Planet-Gear Bearings《行星齿轮轴承的载荷分布分析》.pdf

AGMA 10FTM17-2010 Self-Locking Gears Design and Potential Applications《自动闭锁装置 设计和潜在应用》.pdf

AGMA 1102-B13-2013 Tolerance Specification for Gear Hobs.pdf

AGMA 1103-H07-2007 Tooth Proportions for Fine- Pitch Spur and Helical Gearing (Metric Edition)《小模数直齿轮和斜齿轮用轮齿比例(公制版本)》.pdf

AGMA 1104-A09-2009 Tolerance Specification for Shaper Cutters《插齿刀的公差规范》.pdf

AGMA 1106-A97-1997 Tooth Proportions for Plastic Gears《塑料齿轮齿形尺寸》.pdf

AGMA 11FTM01-2011 A New Way of Face Gear Manufacturing.pdf

AGMA 11FTM02-2011 Generating Gear Grinding C New Possibilities in Process Design and Analysis.pdf