JUS L F2 007-1979 Measurement oj temperature Tabela for rhermomuple Thermocuuple B Pbtinum- 30 7 RHODlUM Platinum-6% Rhodtum《温度测量 热电偶平台 热电偶 B：白金30 7 RHODlUM 白金 6% Rhodtum》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

DIN 6733-2010 Paper - Envelope paper - Requirements test methods《纸张 信封纸 要求和试验》.pdf

DIN 6736-2013 Paper and pulps - Relevant environmental aspects and environmental parameters for paper《纸和纸浆 纸相关环境因素和环境参数》.pdf

DIN 6737-2002 Paper and board - Office board - Requirements test methods《纸和纸板 办公纸板的要求和试验方法》.pdf

DIN 6738-2007 Paper and paper board - Lifespan classes《纸和纸板 使用寿命等级》.pdf

DIN 674-2011 Flat round head rivets - Nominal diameters 1 4 mm to 6 mm《扁圆头铆钉 公差直径1 4 mm至6 mm》.pdf

DIN 6744-1992 Wallpaper base determination of strippability and peelability of wallpaper base and of wallpaper (wallcoverings)《壁纸底层 壁纸底层和壁纸的可剥离性及可剥脱性的测定》.pdf

DIN 675-2011 Flat countersunk head rivets - Nominal diameters 3 mm to 5 mm《平埋头铆钉 公差直径3 mm至5 mm》.pdf

DIN 67500-1987 Illumination of lock areas requirements design and measurement《保险区域的照明 要求、计算及测量》.pdf

DIN 67510-1-2009 Phosphorescent pigments and products - Part 1 Measurement and marking at the producer《磷光颜料及产品 第1部分 生产商处的测量和标记》.pdf