1、MIL-C-24356A(SH) AMENDMENT 2 1 March 1988 MILITARY SPECIFICATION COUPLINGS, SEGMENTED, AND SPLIT CLAMPS REATTACHABLE, 2-1/2-, 4-, 6- AND 7-INCH, FOR REFUELING-AT-SEA HOSE This amendment forms a part of Military Specification MIL-C-24356A(SH), dated 21 April 1982, and is approved for use by the Naval
2、 Sea Systems Command, Department of Che Navy and is available for use by all Departments and Agencies of the Department of Defense. PAGE 1 At bottom of page, Beneficial comments statement, line 3: Delete “3242“ and Substitute “5523“. PAGE 3 * 3.1: Delete and Substitute: * “3.1 First article. When sp
3、ecified in the contract or purchase order, a sample shall be subjected to first article inspection (see 4.3 and 6.4).“ PAGE 6 * 4.2(a) : Delete “Qualification“ and substitute “First article“. * 4.3, lines 1 and 2: Delete “Qualification“ and substitute “First article“. PAGE 7 * 4.3.1: Delete “qualifi
4、cation“ and substitute “first article“. Table IV, title: Delete “qualification“ and substitute “first article“. * 4.3.1.2, line 1: Delete “qualification“ and substitute “first article“. AMSC N/A FSC 4730 DISTRIBUTION STATEMENT A Approved for public release; distribution unlimited 1 of 4 Provided by
5、IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-C-2935bA (2) Li7 = 7779706 027Ll803 7 + MIL-C-24356A(SH) AMENDMENT 2 z PAGE 11 * 6.4: Delete and substitute: * “6.4 First article. When a first article.inspection is required, the item should be a first article
6、 sample. The first article should consist of one unit. The contracting officer should include specific instructions in acquisition documents regarding arrangements for examinations, approval of first article test results and disposition of first articles. Invitations for bids should provide that the
7、 Government reserves the right to waive the requirement for samples for first article inspection to those bidders offering a product which has been previously acquired or tested by the Government, and that bidders offering such products, who wish to rely on such production or test, must furnish evid
8、ence with the.bid that prior Government approval is presently appropriate for the pending contract, ” * 6.4.1: Delete in its entirety. PAGES 13 AND 14 Figures 1 and 2: Delete and substitute the attached figures 1 and 2. LAST PAGE DD 1426, Standardization Document Improvement Proposal: Delete “(SEA 3
9、242)“ and substitute ” (SEA 5523)”. NOTE: The margins of this amendment are marked with an asterisk to indicate where changes (additions, modifications, corrections, deletions) from the previous amendment were made. Government assumes no liability whatsoever for any inaccuracies in these notations.
10、this document based on the entire content irrespective of the marginal notations and relationship to the last previous amendment. This was done as a convenience only and the Bidders and contractors are cautioned to evaluate the requirements of Preparing activity: Navy - SH (Proj ect 4730-N027) 2 Pro
11、vided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-AMENDMENT 2 h +I- O u,I cn u 8 4 v I 2 e H Fri 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-C-24356A(SH) AMENDMENT 2 I I I I I B f 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
