1、P w MIL-I-22062A (2) 58 7797706 0426261 4 I INCH-POUND I MIL-I-22062A(AS) AMENDMENT 2 AMENDMENT 1 1 October 1970 MILITARY SPECIFICATION INTERCONNECT I NG BOX J - 1 O1 3A/AI C This amendment forms a part of MIL-I-22062A(AS) dated 1 September 1969 and is approved for use by the Naval Air Systems Comna
2、nd, Department of the Navy, and is available for use by all Departments and Agencies of the Department of Defense. PAGE 6 *Paragraph 3.3.11.2: Change the last sentence and add an additional sentence as follows: “Anodic treatment is not prohibited, but masking shall be employed to retain the quality
3、of the original metal at the interconnecting box mounting surface and mounting screw holes. Masking shall also be em loyed at the input and output connector surfaces and mounting screw hoyes. II Paragraph 3.3.12: Delete next to last sentence and substitute: amplifier shall not be polarity sensitive.
4、 “The pre- NOTE: The margins of this amendment are marked with asterisks to indicate where changes (additions, modifications, corrections, deletions) from the previous issue were made. This was done as a convenience only and the Govern- ment assumes no 1 iabi 1 i ty whatsoever for any inaccuracies
5、in these notations a Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Preparing activity: (Project No. 5831-NO731 Navy - AS 1 of 1 AMSC N/A FSC 5831 DISTRIBUTION STATEMENT A. Approved for pub1 ic release; distribution is un1 imi ted. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
