NBN T 04-168-1983 0625 Crude glycerine for industrial use- Calculation of Matter (Organic) Non-Glycerol (MONG)《工业用粗甘油 非甘油物质（有机物）的计算》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

GOST 22064-1976 Injection mould bases with take-off and ejector plate Design and dimensions《压力热塑铸造用带起出器板和起箱板压模坯料 结构及尺寸》.pdf

GOST 22065-1976 Plate-blanks of injection moulds Design and dimensions《压力热塑铸造用压模板坯料 结构及尺寸》.pdf

GOST 22066-1976 Clamping plate-blanks of injection moulds Design and dimensions《压力热塑铸造用压模紧固板坯料 结构及尺寸》.pdf

GOST 22067-1976 Cross-forming ejector plate-blanks of injection moulds Design and dimensions《压力热塑铸造用压模顶出器十字形板坯料 结构及尺寸》.pdf

GOST 22068-1976 Rectangular ejector plate-blanks of injection moulds Design and dimensions《压力热塑铸造用压模顶出器矩形板坯料 结构及尺寸》.pdf

GOST 22069-1976 Cross-forming supporting plate-blanks of injection moulds Design and dimensions《压力热塑铸造用压模十字形支撑板坯料 结构及尺寸》.pdf

GOST 22070-1976 Rectangular supporting plate-blanks of injection moulds Design and dimensions《压力热塑铸造用压模矩形支撑板坯料 结构及尺寸》.pdf

GOST 22071-1976 Struts of injection moulds Desing and dimensions《压力热塑铸造用压模支座 结构及尺寸》.pdf

GOST 22072-1976 Guide pins of injection moulds Design and dimensions《压力热塑铸造用压模导向柱 结构及尺寸》.pdf