NEN 6352-1981 Vegetable and animal oils and fats - Determination of the sediment content in raw linseed oil (PAT value)《动植物油脂 生亚麻籽油（PAT值）的沉积物含量的测定》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

STAS 8033-1967 《煅钢凸缘 Pn250型管道头焊接用带喉圆形凸缘大小 尺寸》.pdf

STAS 8033-1984 Steel flanges ROUND NKCK FLANGES FOR WKLUING ON PIPE HEAO NP 250 Dimensions《钢法兰 焊接管接头用的圆颈法兰NP250 尺寸 》.pdf

STAS 8035-1967 《纺织类服装 术语》.pdf

STAS 8036-1981 Cell-autoclaved concrete AERATED CEMENT General technical requirements《细胞蒸压混凝土 充气水泥 一般技术要求 》.pdf

STAS 8037 1-1989 DRILL PIPES WITH WELD-ON TOOL JOINTS《带焊接工具接头的钻杆 》.pdf

STAS 8037 2-1988 DRILL PIPES WITH WELDED JOINTS Rod body《带焊接接头的钻杆 连杆体 》.pdf

STAS 8038-1967 《强流技术的自动化校正系统 常规条件》.pdf

STAS 8039-1990 DEAD-DRAWN STEEL WIRE FOR BICYCLE MOTOR-BIKE AND MOTORCYCLE WHEEL SPOKES《自行车 电动自行车和摩托车车轮辐条的强拉钢丝 》.pdf

STAS 8040-1988 Broaching tools BROACHING FOR SLOTTED HUBS WITH RECTANGULAR SECTION General technical requirements for quality《拉刀 方断面开缝中枢拉削 一般质量技术要求 》.pdf