1、AEROSPACE MATERIAL SPECIFICATIONAMS3898/3 REV. BIssued 1975-06Revised 1994-02Reaffirmed 2014-08Superseding AMS3898/3AInterleaf Carrier Material, Composite TapePolyethylene Coated Paper, Unperforated0.0035 inch (0.089 mm)RATIONALEAMS3898/3B has been reaffirmed to comply with the SAE five year review
2、policy._SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising
3、 therefrom, is the sole responsibility of the user.”SAE reviews each technical report at least every five years at which time it may be revised, reaffirmed, stabilized, or cancelled. SAE invites your written comments and suggestions.Copyright 2014 SAE InternationalAll rights reserved. No part of thi
4、s publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE.TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada)Tel: +1 724-776-49
5、70 (outside USA)Fax: 724-776-0790Email: CustomerServicesae.orgSAE WEB ADDRESS: http:/www.sae.orgSAE values your input. To provide feedbackon this Technical Report, please visithttp:/www.sae.org/technical/standards/AMS3898/3B1. SCOPE:1.1 Form:This specification covers one type of paper coated on both
6、 sides withpolyethylene film in the form of rolls of sheeting or reels of unperforatedtape of the width specified.2. APPLICABLE DOCUMENTS:See AMS 3898.3 TECHNICAL REQUIREMENT3.1 Basic Specification:The complete requirements for procuring the product described herein shallconsist of this document and
7、 the latest issue of the basic specification,AMS 3898.3.2 Material:The carrier material shall be a paper coated on each side with a polyethylenefilm.3.2.1 Thickness: Shall be 0.0035 inch .0005 (0.089 mm 0.013).3.2.2 Width: Shall be as ordered.3.3 Properties:Shall be as shown in Table 1.SAE INTERNATI
8、ONAL AMS3898/3B Page 2 of 2 TABLE 1 - PropertiesParagraph Property3.3.1 Tensile Strength, minimumRequirement Test MethodASTM D 882,Method A25 pounds forceper inch(4.38 kN/m) of width3.3.2 Tear Strength, minimum 1.75 ounces force(487 mN)ASTM D 827-714.5.6.7.8.QUALITY ASSURANCE PROVISIONS:See AMS 3898.PREPARATION FOR DELIVERY:See AMS 3898.ACKNOWLEDGMENT:See AMS 3898.REJECTIONS:See AMS 3898.NOTES:See AMS 3898.
