1、 AEROSPACE STANDARD PLUG, MACHINE THREAD AMS 5646, METAL GASKET, SILVER PLATED, REDUCED DIAMETER THREAD AS3001Copyright 2015 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mec
2、hanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org ISSUED 1963-06REAFFI
3、RMED2015-04THIRD ANGLE PROJECTION CUSTODIAN: E-25 FEDERAL SUPPLY CLASS AS3001 SHEET 1 OF 3 SAE Technical Standards Board Rules provide that: “This report ispublished by SAE toadvance thestate of technicalandengineering sciences. Theuse ofthisreport is entirelyvoluntary, andits applicability and suit
4、ability forany particularuse,including any patent infringement arising therefrom, isthe soleresponsibilityofthe user.”SAE reviews eachtechnicalreport at least every five years at which time itmay berevised,reaffirmed, stabilized, orcancelled. SAE invites yourwrittencomments andsuggestions. SAE value
5、s your input. To provide feedbackon this Technical Report, please visit http:/www.sae.org/technical/standards/AS3001 RATIONALE AS3001 HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE FIVE-YEAR REVIEW POLICY. AEROSPACE STANDARD AS3001 SHEET 2 OF 3 PLUG, MACHINE THREAD AMS 5646, METAL GASKET, SILVER PLATED,
6、 REDUCED DIAMETER THREAD TABLE 1AEROSPACE STANDARD AS3001 SHEET 3 OF 3 PLUG, MACHINE THREAD AMS 5646, METAL GASKET, SILVER PLATED, REDUCED DIAMETER THREAD NOTES:1. HEXAGON SHALL BE CONCENTRIC WITH THREAD PD WITHIN J FIR.2. DIAMETER H SHALL BE CONCENTRIC WITH THREAD PD WITHIN .005 FIR.3. MATERIAL: CO
7、RROSION AND HEAT RESISTANT STEEL AMS 5646.4. FINISH: SILVER PLATE AMS 2410 .0003-.0006 THICK ON THREAD AT PD, PLATING ON OTHER SURFACES OPTIONAL. DIMENSIONS SPECIFIED ARE AFTER PLATING. THREAD PD MAY BE MODIFIED .0012 MAX BEFORE PLATING.5. SURFACE ROUGHNESS: AS291. UNLESS OTHERWISE SPECIFIED SURFACES TO BE 125 MICROINCHES.6. PARTS SUBJECT TO FLUORESCENT PENETRANT INSPECTION PER AMS 2645.7. BREAK SHARP EDGES .003-.015 UNLESS OTHERWISE SPECIFIED.8. DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, TOLERANCES: LINEAR DIMENSIONS .010, ANGULAR DIMENSIONS 5.9. DO NOT USE UNASSIGNED PART NUMBERS.
