1、 AEROSPACE STANDARD CABLE, ELECTRIC, FILTER LINE, UNSHIELDED, UNJACKETED, MULTIPLE-COMPONENT, RADIO FREQUENCY ABSORPTIVE, 150C, 600-VOLT AS85485/7 Copyright 2004 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any
2、form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: custsvcsae.org SAE WEB ADDRESS: http:/www.sa
3、e.org ISSUED 2004-06THIRD ANGLE PROJECTION CUSTODIAN: SAE AE-8/AE-8D FEDERAL SUPPLY CLASS6145 AS85485/7SHEET 1 OF 3 PROCUREMENT SPECIFICATION: MIL-C-85485SAE TechnicalStandards Board Rules provide that: “This report is published by SAE toadvance thestate of technical andengineering sciences. Theuse
4、ofthisreportisentirelyvoluntary, andits applicabilityandsuitability forany particularuse,including any patent infringement arising therefrom, is thesole responsibility oftheuser.” SAE reviews each technical report at least every five yearsat which time it may be reaffirmed, revised, orcancelled.SAE
5、invites yourwritten commentsandsuggestions. NOTICE THIS DOCUMENT HAS BEEN TAKEN DIRECTLY FROM U.S. MILITARY SPECIFICATION MIL-C-85485/7 AND CONTAINS ONLY MINOR EDITORIAL AND FORMAT CHANGES REQUIRED TO BRING IT INTO CONFORMANCE WITH THE PUBLISHING REQUIREMENTS OF SAE TECHNICAL STANDARDS. THE INITIAL
6、RELEASE OF THIS DOCUMENT IS INTENDED TO REPLACE MIL-C-85485/7. ANY PART NUMBERS ESTABLISHED BY THE ORIGINAL SPECIFICATION REMAIN UNCHANGED. THE ORIGINAL MILITARY SPECIFICATION WAS ADOPTED AS AN SAE STANDARD UNDER THE PROVISIONS OF THE SAE TECHNICAL STANDARDS BOARD (TSB) RULES AND REGULATIONS (TSB 00
7、1) PERTAINING TO ACCELERATED ADOPTION OF GOVERNMENT SPECIFICATIONS AND STANDARDS. TSB RULES PROVIDE FOR (A) THE PUBLICATION OF PORTIONS OF UNREVISED GOVERNMENT SPECIFICATIONS AND STANDARDS WITHOUT CONSENSUS VOTING AT THE SAE COMMITTEE LEVEL, AND (B) THE USE OF THE EXISTING GOVERNMENT SPECIFICATION O
8、R STANDARD FORMAT. UNDER DEPARTMENT OF DEFENSE POLICIES AND PROCEDURES, ANY QUALIFICATION REQUIREMENTS AND ASSOCIATED QUALIFIED PRODUCTS LISTS ARE MANDATORY FOR DOD CONTRACTS. ANY REQUIREMENT RELATING TO QUALIFIED PRODUCTS LISTS (QPLS) HAS NOT BEEN ADOPTED BY SAE AND IS NOT PART OF THIS TECHNICAL RE
9、PORT. Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-AEROSPACE STANDARD CABLE, ELECTRIC, FILTER LINE, UNSHIELDED, UNJACKETED, MULTIPLE-COMPONENT, RADIO FREQUENCY ABSORPTIVE, 150C, 600-VOLT AS85485/7
10、 AS85485/7SHEET 2 OF 3 FIGURE 1. TYPICAL CONFIGURATION. RATINGS: TEMPERATURE RATING: 150C (302F) MAX CONTINUOUS CONDUCTOR TEMPERATURE VOLTAGE RATING: 600 VOLTS (RMS) AT SEA LEVEL ADDITIONAL REQUIREMENTS: ATTENUATION (INSERTION LOSS): THE CABLE OF THIS SPECIFICATION SHEET MEETS THE ATTENUATION REQUIR
11、EMENTS FOR THE APPLICABLE WIRE SIZE AND NUMBER OF COMPONENTS WHEN SHIELDED IN ACCORDANCE WITH M85485/8-*. CONSULT QPL SOURCE FOR DETAILS. INSULATION FLAWS: SPARK TEST - 3.0 KILOVOLTS (RMS), 60 HZ IMPULSE DIELECTRIC TEST - 8.0 KILOVOLTS (PEAK) THERMAL STABILITY: 1250 HOURS AT 180 3C (356 5F). THE CAB
12、LE OF THIS SPECIFICATION SHEET, WHEN SHIELDED IN ACCORDANCE WITH M85485/8-*, SHALL MEET THE VOLTAGE WITHSTAND (DIELECTRIC) OF 1500 VOLTS (RMS) 60 HZ AND THE STOP BAND ATTENUATION REQUIREMENTS FOR THE APPLICABLE COMPONENT WIRE SIZE AND NUMBER OF COMPONENTS. CONSULT QPL SOURCE FOR DETAILS. VOLTAGE WIT
13、HSTAND (DIELECTRIC): CONDUCTOR TO CONDUCTOR 1500 VOLTS (RMS) 60 HZ Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-AEROSPACE STANDARD CABLE, ELECTRIC, FILTER LINE, UNSHIELDED, UNJACKETED, MULTIPLE-CO
14、MPONENT, RADIO FREQUENCY ABSORPTIVE, 150C, 600-VOLT AS85485/7 AS85485/7SHEET 3 OF 3 TABLE I. CONSTRUCTION DETAILS. APPLICATION NOTES: THE COMPONENT WIRES IN THESE CONSTRUCTIONS ARE EFFECTIVE RADIO FREQUENCY ABSORPTIVE WIRES ONLY WHEN USED AS COMPONENTS IN A SHIELDED CABLE. THE COMPONENT WIRES OF M85
15、485/7 ARE COMPATIBLE WITH ALL STANDARD CONNECTOR AND CONTACT TYPES, EXCEPT THAT THE PRIMARY JACKET DIAMETERS OF M85485/5-22 COMPONENT WIRES EXCEED THE ALLOWABLE DIAMETER FOR MIL-C-38999 SIZE 22D CONTACTS. HOWEVER, THESE COMPONENT WIRES CAN BE TERMINATED TO SIZE 22D CONTACTS IF THE PRIMARY JACKET AND
16、 FILTER LAYER ARE STRIPPED IN THE GROMMET AREA, LEAVING THE PRIMARY INSULATION INTACT. QUALIFYING ACTIVITY: THE ACTIVITY RESPONSIBLE FOR THIS QUALIFIED PRODUCTS LIST IS THE NAVAL AIR SYSTEMS COMMAND, WASHINGTON, D.C. 20361. Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
