1、SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirelyvoluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefro
2、m, is the sole responsibility of the user.”SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions.Copyright 2007 SAE InternationalAll rights reserved. No part of this publication may be
3、reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying,recording, or otherwise, without the prior written permission of SAE.TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada)Tel: 724-776-4970 (outside USA)Fax: 724-
4、776-0790Email: CustomerServicesae.orgSAE WEB ADDRESS: http:/www.sae.orgSURFACEVEHICLERECOMMENDEDPRACTICEJ1332REAF.NOV2007Issued 1981-10Reaffirmed 2007-11Superseding J1332 OCT1981Rope Drum Rotation Indicating Device1. ScopeThis SAE Recommended Practice applies to cranes when used in lifting crane ser
5、vice which areequipped with rope drum rotation indicating devices.1.1 PurposeThe purpose of this recommended practice is to establish the minimum performance requirementsfor devices used to indicate to the crane operator by visual, audible, or tactile means the movement of a ropedrum.2. ReferencesTh
6、ere are no referenced publications specified herein.3. Definitions3.1 Rope Drum Rotation Indiciating Device (hereafter called Device)A device used to indicate to the craneoperator by visual, audible, or tactile means the movement of a rope drum.4. Minimum Performance Criteria4.1 The device sensor is
7、 to monitor rope drum movement to identify and transmit this information to the craneoperator by using one or more of the following methods:4.1.1 VISUAL INDICATIONThe visual indication is to be clearly distinguishable to the operator.4.1.2 AUDIBLE INDICATIONThe audible signal is to be clearly distin
8、guishable to the operator from the noise of theengines, machinery, and any other audible warning device.4.1.3 TACTILE INDICATIONThe tactile indicator is to be located so that the crane operator may monitor drumrotation while operating the controls.4.1.4 None of the above indications shall cause oper
9、ator discomfort or cause any operational hazard.4.2 The Device is to be sufficiently responsive to indicate initial drum rotation producing rope travel of 50 mm(2 in). The Device is to differentiate rope speeds less than 1 m/s and will accommodate all speedsrecommended by the crane manufacturer.SAE
10、J1332 Reaffirmed NOV2007-2-4.3 The Device is to indicate the direction of rope travel when not otherwise indicated by control position.4.4 Temperature EffectThe Device is to operate over ambient temperature variations of 30 to +50 C (22 to+122 F).4.5 TestingThe Device is to be initially tested to es
11、tablish compliance with 4.2, 4.3, and 4.4.5. General Requirements5.1 Installation and MaintenanceInstallation and maintenance of the Device is to be in accordance with themanufacturers recommendation to attain performance consistent with minimum requirements (Section 4).5.2 IdentificationA label, wh
12、en applicable, is to be provided giving the Device manufacturers name, address,and model number.PREPARED BY THE SAE OFF-ROAD MACHINERY TECHNICAL COMMITTEE SC17EXCAVATORSREAFFIRMED BY THE SAE OFF-ROAD MACHINE TECHNICAL COMMITTEE SC31CRANES AND LIFTING DEVICESSAE J1332 Reaffirmed NOV2007RationaleNot a
13、pplicable.Relationship of SAE Standard to ISO StandardNot applicable.ApplicationThis SAE Recommended Practice applies to cranes when used in lifting crane service which areequipped with rope drum rotation indicating devices.Reference SectionThere are no referenced publications specified herein.Developed by the SAE Off-Road Machinery Technical Committee SC17ExcavatorsSponsored by the SAE Off-Road Machinery Technical Committee
