SIS SS 21 25 25-1983 Steel - Round bar cold worked - Dimensions and tolerances《钢 圆棒，冷加工尺寸和公差》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

NF T47-303-1977 Materials for rubber-based pre-formed joints for use between concrete paving stones Characteristics joints for airport runways 《混凝土铺路石板之间用橡胶基预成形连接件 特性 机场跑道用特性连接材料》.pdf

NF T47-304-1983 Reforced rubber compensating sleebes 《增强式橡胶补偿套管》.pdf

NF T47-305-1 A1-1999 Elastomeric seals - Material requirements for pipe joint seals used in water and drainage applications - Part 1 Vulcanized rubber 《NF EN 681-1-1996的修改件1》.pdf

NF T47-305-1-1996 Elastomeric seals Materials requirements for pipe joint seals used in water and drainage applications Part 1 vulcanized rubber 《弹性密封件 排水设备用管接头密封件用材料的要求 第1部分 硫化橡胶.pdf

NF T47-502-1996 O rings Dimensional checking and classification of defects 《O形圈 缺陷的尺寸检查和分类》.pdf

NF T47-503-1998 Rubber O-rings Materials requirements for the most common O-ring types 《橡胶O形密封圈 最通用型O形密封圈的材料要求》.pdf

NF T47-506-1991 Rubber O-rings Test conditions and methods for full-size specimens 《橡胶O形密封圈 全尺寸试样的试验条件和方法》.pdf

NF T47-507-2006 Rubber O-rings - Packaging identification and storage of rubber O-rings 《橡胶O形环 橡胶O形环的包装、标识和储存》.pdf

NF T47-820-11-1998 Structural bearings Part 11 transport storage and installation 《结构轴承 第11部分 运输、存储和安装》.pdf