SIS SS-IEC 721-1991 Classification of environmental conditions《环境条件分类》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

JUS K D2 076-1990 Single-angle cutters Technical requirements《单角切割器 技术要求》.pdf

JUS K D2 077-1990 Double equal~angle cutters Technical reguirements《双等角切割器 技术要求》.pdf

JUS K D2 083-1990 Angle-cutters for toolmarking Technical requirements《制造工具的角度切割器 技术要求》.pdf

JUS K D2 089-1984 End mi Us Technical requirements《终端磨机 技术要求》.pdf

JUS K D2 090-1983 Parallel shank end mills《平行柄终端磨机》.pdf

JUS K D2 092-1983 Morse tapershank end mills《莫氏锥柄终端磨机》.pdf

JUS K D2 093-1984 7 24 taper shank and mills《7 24 锥柄终端磨机》.pdf

JUS K D2 094-1984 7 24 taper shank end mili Technical requirements《7 24 锥柄及磨机 技术要求》.pdf

JUS K D2 095-1984 Parallel shank and mills high power type《平行柄及磨机 高能型》.pdf