TCVN 7572-16-2006 Aggregates for concrete and mortar Test methods Part 16 Determination of sulfate and sulfite content《混凝土和灰浆用集料 试验方法 第16部分 硫酸盐和亚硫酸盐含量的测定》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

SR CEI 255-3-1995 Electrical relays Part 3 Single input energizing quantity measuring relays with dependent or independent time《继电器 第3部分：带有独立和非独立时间的单输入发电量测量继电器》.pdf

SR CEI 255-7-1991 Electrical relays Part 7 Test and measurement procedures for electromechanical all-or-nothing relays《继电器第7部分：电气试验和测量程序 机电全有或全无继电器》.pdf

SR CEI 317-0-2 C1-1996 Specifroations for particular types of winding wires Part O- Generai requirernents Sectton 2 - Enameiled rectangular coppre vire《绕组线的特殊类型的规格 第0部分：一般要求 第2节：方截.pdf

SR CEI 317-0-2-1995 Specifications for particular types of winding wires Part 0 General requiiements Section 2 - Enamelled rectangular copper wire《特定类型绕组线规格 第0部分：一般要求 部分2：搪瓷方形铜线》.pdf

SR CEI 317-32-1995 Specifications for particular types of winding wires Part 32 Glass-fibre wound polyester or polyesterimide varnish-treated bare or enamelled rectangular copper w.pdf

SR CEI 326-1-1996 Printed boards Part 1 General information for the specification writer《印刷电路板 第1部分：规格写入器的一般信息》.pdf

SR CEI 34-15-1990 Rotating electrical machines Part 15 Impulse voitage withstand levels of rotating a c machines with form-wound stator coits《旋转电机 第15部分：脉冲电压承受水平旋转交流机器形式伤口定子线圈》.pdf

SR CEI 34-16-1-1991 Rotating electrical machines Part 16 Excitation systems for synchronous machines Chapter 1 Definitions《旋转电机 第16部分：同步机的励磁系统 第1章：定义》.pdf

SR CEI 34-5-1993 Rotating electrical machines Part 5 Classification of degrees of protection provided by enclosures of rotating electrical machines (IP code)《旋转电机 第5部分：旋转电机罩所提供的保护程.pdf