UNE 11-015-1989 《桌子 确定稳定性的试验方法》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

SAE AS 1895 3C-1996 FLANGE FEMALE SEAM WELD TYPE I STANDARD PROFILE《标准外形的I型滚焊带槽法兰》.pdf

SAE AS 1895 4D-2003 COUPLING V-RETAINER SINGLE LATCH TYPE II LOW PROFILE《扁平外形的II型单锁V型固定器连接器》.pdf

SAE AS 1895 5C-1996 FLANGE MALE SEAM WELD TYPE II LOW PROFILE《II型低剖面焊缝凸型法兰》.pdf

SAE AS 1895 6C-1996 FLANGE FEMALE SEAM WELD TYPE II LOW PROFILE《扁平外形的II型滚焊带槽法兰》.pdf

SAE AS 1895 7F-2017 SEAL TYPE I & II STANDARD AND LOW PROFILE.pdf

SAE AS 1895 8C-1996 FLANGE MALE BUTT WELD TYPE II LOW PROFILE《扁平外形的II型对接焊凸面法兰》.pdf

SAE AS 1895 9C-1996 FLANGE FEMALE BUTT WELD TYPE II LOW PROFILE.pdf

SAE AS 1896A-1991 Coupling Assembly Self-Sealing One Side Only Hydraulic《一侧自密封液压连接器总成》.pdf

SAE AS 1909C-2003 Hose Assembly Polytetrafluoroethylene CRES Reinforced 400 F 3000 psi Lightweight Beam Seal Straight to Straight《180对180光束密封轻质400 F、3000 psi、CRES加固的聚四氟乙烯软管组件》.pdf