UNE 18-106-1986 《轴承 允差 定义》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

SANS 1609-1-2005 Radio transmissions in the VHF band Part 1 Transmission standards for FM sound broadcasting《甚高频无线电传输 第1部分：FM声音广播传输标准》.pdf

SANS 161-2-1997 Plastics - Polypropylene (PP) moulding and extrusion materials Part 2 Preparation of test specimens and determination of properties《塑料 聚丙烯(PP)模塑和挤塑材料 第2部分：试样制备和性能测定.pdf

SANS 1611-2005 The mechanical requirements for satellite television receiving antennas《卫星电视接收天线的结构参数》.pdf

SANS 1612-2007 Paper punches (desk top types)《纸张打孔器（台式）》.pdf

SANS 1613-2007 Warp-knitted terry towelling fabric and articles《经编毛巾布织物》.pdf

SANS 16132-2010 Ductile iron pipes and fittings - Seal coats for cement mortar linings《球墨铸铁管和配件 水泥灰浆衬套的封装层》.pdf

SANS 16133-2003 Rubber and plastics - Analysis of multipeak traces obtained in determinations of tear strength and adhesion strength《橡胶及塑料 在撕裂强度及粘接强度测定中获得的多峰图形曲线分析》.pdf

SANS 16135-2009 Industrial valves - Ball valves of thermoplastics materials《工业阀门 热塑材料球阀》.pdf

SANS 16147-2008 Small craft - Inboard diesel engines - Engine-mounted fuel and electrical components《小艇 舷内柴油机 机装燃油和电气部件》.pdf