UNIT 15-1943 《平面褶皱》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

NF J45-925-1948 Shipbuilding Voice-pipes Special calling-uptubes Mouthpiece and whistle 《造船工业 传话管 呼救专用管 连接管和气笛》.pdf

NF J45-927-1948 SHIPBUILDING VOICE-PIPES DRAIN PLUG 《造船工业 传话筒 清扫口塞》.pdf

NF J52-216-1997 Shipbuilding Trawl winches 《造船工业 拖网绞车》.pdf

NF J65-100-1958 Shipbuilding Shaft lines General specification Nominal diameters 《造船工业 轴线 一般规范 标称直径》.pdf

NF J65-105-1958 Shipbuilding Shaft lines Propeller-shaft-ends 《造船工业 轴线 螺旋桨轴端》.pdf

NF J65-106-1958 Shipbuilding Shaft lines Gauges for machining taper assemblies Arrangement conditions 《造船工业 轴线 锥体组件机加工用量规 排列情况》.pdf

NF J65-107-1958 Shipbuilding Shaft lines Keys and keyways for tapers on propeller shafts Diameters 110 mm to 680 mm 《造船工业 轴线 直径为110mm－680mm的螺旋尾轴锥形体的键接》.pdf

NF J65-108-1958 Shipbuilding Shaft lines Keys and keyways for tapers on propeller-shafts Diameters 100 mm to 680 mm Alternative 《造船工业 轴线 直径为110mm－680mm的螺旋桨轴上锥形体的键和键槽 可选择的》.pdf

NF J65-109-1958 Shipbuilding Shaft lines Collar nuts for propellers 《造船工业 轴线 螺旋桨用环形螺母》.pdf