1、 IEC 61169-4 Edition 1.0 2008-04 INTERNATIONAL STANDARD NORME INTERNATIONALE Radio-frequency connectors Part 4: RF coaxial connectors with inner diameter of outer conductor 16 mm (0,63 in) with screw lock Characteristic impedance 50 (type 7-16) Connecteurs pour frquences radiolectriques Partie 4: Co
2、nnecteurs coaxiaux pour frquences radiolectriques de diamtre intrieur du conducteur extrieur de 16 mm (0,63 in) verrouillage vis Impdance caractristique 50 (type 7-16) IEC 61169-4:2008-04(EN-FR) colour inside THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2008 IEC, Geneva, Switzerland All rights
3、reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester
4、. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de c
5、ette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lIEC ou du Comit national de lIEC du pays du demandeur. Si vous avez des questions sur le copyright de lIEC o
6、u si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de lIEC de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.ie
7、c.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under consta
8、nt review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. IEC Catalogue - webstore.iec.ch/catalogue The stand-alone application for consulting the entire bibliographical information on IEC International Standards, Technical Speci
9、fications, Technical Reports and other documents. Available for PC, Mac OS, Android Tablets and iPad. IEC publications search - www.iec.ch/searchpub The advanced search enables to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives information
10、 on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications. Just Published details all new publications released. Available online and also once a month by email. Electropedia - www.electropedia.org The worlds lea
11、ding online dictionary of electronic and electrical terms containing more than 30 000 terms and definitions in English and French, with equivalent terms in 14 additional languages. Also known as the International Electrotechnical Vocabulary (IEV) online. IEC Glossary - std.iec.ch/glossary More than
12、55 000 electrotechnical terminology entries in English and French extracted from the Terms and Definitions clause of IEC publications issued since 2002. Some entries have been collected from earlier publications of IEC TC 37, 77, 86 and CISPR. IEC Customer Service Centre - webstore.iec.ch/csc If you
13、 wish to give us your feedback on this publication or need further assistance, please contact the Customer Service Centre: csciec.ch. A propos de lIEC La Commission Electrotechnique Internationale (IEC) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce
14、 qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications IEC Le contenu technique des publications IEC est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Catalogue IEC - webstore
15、.iec.ch/catalogue Application autonome pour consulter tous les renseignements bibliographiques sur les Normes internationales, Spcifications techniques, Rapports techniques et autres documents de lIEC. Disponible pour PC, Mac OS, tablettes Android et iPad. Recherche de publications IEC - www.iec.ch/
16、searchpub La recherche avance permet de trouver des publications IEC en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. IEC Just Published - webstore.iec.ch/justpublished Restez inform s
17、ur les nouvelles publications IEC. Just Published dtaille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne de termes lectroniques et lectriques. Il contient plus de 30 000 termes et dfini
18、tions en anglais et en franais, ainsi que les termes quivalents dans 14 langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (IEV) en ligne. Glossaire IEC - std.iec.ch/glossary Plus de 55 000 entres terminologiques lectrotechniques, en anglais et en franais, extraites d
19、es articles Termes et Dfinitions des publications IEC parues depuis 2002. Plus certaines entres antrieures extraites des publications des CE 37, 77, 86 et CISPR de lIEC. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questi
20、ons contactez-nous: csciec.ch. IEC 61169-4 Edition 1.0 2008-04 INTERNATIONAL STANDARD NORME INTERNATIONALE Radio-frequency connectors Part 4: RF coaxial connectors with inner diameter of outer conductor 16 mm (0,63 in) with screw lock Characteristic impedance 50 (type 7-16) Connecteurs pour frquence
21、s radiolectriques Partie 4: Connecteurs coaxiaux pour frquences radiolectriques de diamtre intrieur du conducteur extrieur de 16 mm (0,63 in) verrouillage vis Impdance caractristique 50 (type 7-16) INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE T ICS 29.120.10 P
22、RICE CODE CODE PRIX ISBN 978-2-8322-1353-7 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtained this publication from an authorized distributor. Attention! Veuillez vous assurer que vo
23、us avez obtenu cette publication via un distributeur agr. colour inside 2 61169-4 IEC:2008 CONTENTS FOREWORD . 4 1 Scope . 6 2 Normative references . 6 3 Mating face and gauge information . 6 3.1 Dimensions General connectors Grade 2 7 3.1.1 Connector with pin centre contact 7 3.1.2 Connector with s
24、ocket centre contact 8 3.2 Gauges for general purpose connectors - Grade 2 9 3.2.1 Gauges for connector with socket centre contact . 9 3.3 Dimensions standard test connectors Grade 0 . 10 3.3.1 Standard test connector with pin centre contact . 10 3.3.2 Standard test connector with socket centre cont
25、act . 10 4 Quality assessment procedures 11 4.1 General . 11 4.2 Ratings and characteristics . 11 4.3 Test Schedule and Inspection requirements 14 4.3.1 Acceptance tests . 14 4.3.2 Periodic tests 15 4.4 Procedures 16 4.4.1 Quality conformance inspection . 16 4.4.2 Qualification approval and its main
26、tenance 16 5 Instructions for preparation of detail specifications . 17 5.1 General . 17 5.2 Identification of the Detail specification . 17 5.3 Identification of the component 17 5.4 Performance 17 5.5 Marking, ordering information and related matters . 18 5.6 Selection of tests, test conditions an
27、d severities 18 5.7 Blank detail specification pro-forma for type 7-16 connector 19 Figure 1 Connector with pin centre contact 7 Figure 2 Connector with socket centre contact . 8 Figure 3 Gauge pin for socket centre contact . 9 Figure 4 Gauge ring for socket outer contact 9 Figure 5 Slotted centre c
28、ontact 11 Table 1 Connector with pin centre contact. 7 Table 2 Connector with socket centre contact 8 Table 3 Tolerance for the standard connector with pin centre contact. . 10 Table 4 Tolerance for the standard connector with socket centre contact . 10 Table 5 Slotted centre contact . 11 Table 6 Pr
29、eferred climatic categories (see IEC 60068-1):. 12 Table 7 Ratings and characteristics . 13 61169-4 IEC:2008 3 Table 8 Acceptance tests . 14 Table 9 Periodic tests 15 4 61169-4 IEC:2008 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ RADIO-FREQUENCY CONNECTORS Part 4: RF coaxial connectors with inner di
30、ameter of outer conductor 16 mm (0,63 in) with screw lock Characteristic impedance 50 (type 7-16) FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object
31、of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications
32、(PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising
33、 with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, a
34、s nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees i
35、n that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Comm
36、ittees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC provides no marking
37、procedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with an IEC Publication. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or
38、 agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use
39、 of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that s
40、ome of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 61169-4 has been prepared by subcommittee 46F: RF and microwave passive components, of IEC technical committee
41、46: Cables, wires, waveguides, r.f. connectors, r.f. and microwave passive components and accessories.This standard cancels and replaces IEC/PAS 61169-4 published in 2006. This first edition constitutes a technical revision. This bilingual version (2014-01) corresponds to the monolingual English ver
42、sion, published in 2008-04. The text of this standard is based on the following documents: FDIS Report on voting 46F/60/FDIS 46F/71/RVD 61169-4 IEC:2008 5 Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. The French ve
43、rsion of this standard has not been voted upon. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. A list of all parts of IEC 61169 series, published under the general title Radio-frequency connectors, can be found on the IEC website. The committee has decided that
44、the contents of this publication will remain unchanged until the maintenance result date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amende
45、d. IMPORTANT The colour inside logo on the cover page of this publication indicates that it contains colours which are considered to be useful for the correct understanding of its contents. Users should therefore print this document using a colour printer. 6 61169-4 IEC:2008 RADIO-FREQUENCY CONNECTO
46、RS Part 4: RF coaxial connectors with inner diameter of outer conductor 16 mm (0,63 in) with screw lock Characteristic impedance 50 (type 7-16) 1 Scope This part of IEC 61169, which is a sectional specification (SS), provides information and rules for the preparation of detail specifications (DS) fo
47、r type 7-16 R.F. coaxial connectors with screw lock. The connectors are normally used with 50 flexible and semi-rigid r.f. cables for middle power applications in an operating frequency range up to 7,5 GHz. It describes the interface dimensions for general purpose grade 2 connectors, dimensional det
48、ails for standard test connectors, grade 0, together with gauging information and the mandatory tests selected from QC 22000 (IEC 61169-1), applicable to all DS relating to type 7-16 connectors. This specification indicates the recommended performance characteristics to be considered when writing a
49、DS and covers test schedules and inspection requirements. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 61169-1, Radio-freque
