MNOSZ 9823-1952 《搪瓷产品一般部件》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

SN 253 135-1984 Safety regulations for construction of refrigerated rooms《高压支座绝缘子规则》.pdf

SN 253 171-1985 Refrigerating plants - Safety devices《插接触点250V，6A，2P适用于仪器和机器组装 量规》.pdf

SN 253 171-1988 Refrigerating plants - Safety devices《四角手柄；曲柄和手轮的内四角 主轴的外四角》.pdf

SN 257 800-1988 Coordinate metrologyGeometrical fundamental principles terms and definitions《插塞式熔断器2÷10A，250V，2÷60A，500V》.pdf

SN 258 250-1978 Electrical discharge machiningPart 3 Design and Operation of the equipment《管道 法兰，密封嵌条概览 尺寸 ND1至40，NW 600至4000》.pdf

SN 258 251-1985 Surface roughness - Attainable surface roughnesswith different manufacturing methods《空心铆钉 额定直径 1 8 mm 形状 A，带有扁头》.pdf

SN 258 405-1979 Die Angaben in dieser Norm entsprechen weitgehend den Fest-legungen der von der Internationalen Organisation für Nor-mung ISO herausgegebenen In.pdf

SN 258 440-1983 General tolerances for linear and angular dimensionsformed by metal removal or from sheet metal《带有内螺纹的锥形销钉》.pdf

SN 258 460-1981 Conical tapersTaper angles and conical tapers《带有齿槽的轻型夹紧销》.pdf