1、INCH-POUND MIL-DTL-11484/321 30 September 2008 DETAIL SPECIFICATION SHEET LAPEL BUTTON, RESPONSE SERVICE, PUBLIC HEALTH SERVICE This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consi
2、st of this specification sheet and the latest issue of MIL-DTL-11484. MATERIAL: Gilding Metal or Rich-Low Brass FINISH: Hard Enameled or Epoxied, Gold Plated Mirror-like Polished and shall match The Institute of Heraldry (TIOH) Metal Finish Chip Number 6. DIMENSIONS: HEIGHT: 9/64 inch (REF) WIDTH: 2
3、1/32 inch (REF) THICKNESS: 0.060 0.01 inch NOTES: 1. The term (REF) refers to the measurements taken from the Government furnished hub or die. 2. Attaching device shall be prong with pick and flat ball type clutch. The prong shall be centered on the reverse side and fused or soldered to the lapel bu
4、tton. AMSC N/A Page 1 of 2 FSC 8455 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-11484/321 Page 2 of 2 3. Enameled/epoxied areas shall be as shown. When hard enamel is used, the material requirement shall be 95/5 gilding metal. When epoxy
5、is used, the material requirement shall be 85/15 rich-low brass (or better). Colors shall conform to TIOH Hard Enamel Color Chip Numbers listed: COLOR CHIP NUMBER Maroon Green 6 12 Dark Blue 20 White 28 Yellow 31 Lt. Blue 33 Custodian: Preparing activity: Army - IH Army - IH (Project No. 8455-2008-2
6、06) Review activities: DLA - CT NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
